A4Tech RBW5N Users Manual

RF Mouse

User’s Guide

MODEL: RBW-5

Trademark Recognition

Windows, Office 97/2000/XP and MS-IntelliMouse are registered trademarks of Microsoft Corp.

—

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Federal Communications Commission Requirements

The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equip ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

z Reorient of relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

z Consult the dealer or an experienced radio/TV technician for help. The changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

—

NNTTRROODDUUCCTTIIOON

Congratulations on your purchase! Your new RF-Mouse is easy to install and offers you a host of useful features. The Radio receiver can be conveniently placed to give you the freedom you need while working. The vertical wheel allows you to scroll, or zoom in and out in a document. You can program the mouse buttons to launch the NetJump or LuckyJump for a quick start to programs you run frequently. And, your RF-Mouse has a unique ID code, so other RF (Radio Frequency) pointing devices won’t affect your system.

Connecting the RF-Mouse Receiver

 To connect your mouse receiver to a USB mouse port:

Locate an available USB mouse port on the back of your computer.

Insert the USB mouse port connector into the USB mouse port.

 To connect your mouse receiver to a PS/2 mouse port

1. Locate an available round 6-pin PS/2 mouse port on the back of your computer

2. Insert the USB connector to PS/2 adaptor.

3. Then plug it into the round 6-pin PS/2 mouse port.

Locating the RF-Mouse Receiver

Your RF-Mouse has limitations on the range or distance from the receiver. To make sure that your mouse sends and receives properly, refer to the following:

1. For optimal performance, place the receiver at least 8 inches (20 centimeters) away from other

electrical devices, such as the computer, the monitor, or external storage drives.

2. The RF-Mouse should be no farther than 3.3 feet (1.0 meter) from the mouse receiver. This will

ensure optimal communication between the mouse and receiver.

3. If you are working on a metallic surface, try using a mouse pad and turning the receiver face down

for better reception.

4. Switch frequency channels to prevent interference from other RF pointing devices. (See the

following section for more information.)

+ 4 hidden pages