3M SS EPE-316L User Manual
Models:
SS EPE-316L Series
Spec #
Quantity
Applications:
• Sediment / Rust
• Chlorine Taste & Odor
• Scale
SS8 EPE-316L
Whole House Water Filters
At a Glance:
• Electropolish premium exterior fi nish
• For hot and cold water applications
• 1-1/2” NPT to 3” 150# fl anged pipe size
• Provides fl ow rates up to 384 gpm (1,454 lpm)
Product Benefi ts:
• Heavy-duty 316L (low carbon) stainless steel head and housing rated to 150 psi
(1,034 kPa)
• Accommodates a variety of cartridge sizes and options from 9-3/4” - 40”
• Electropolish exterior fi nish provides mirror-like fi nish and is resistant to corrosion
• Manufactured from FDA CFR-21 compliant materials
• High fl ow design up to 384 gpm (1,454 lpm) and temperature rating up to 250°F
(121°C) to meet multiple application requirements for residential to light commercial/
industrial
SS4 EPE-316L
SS12 EPE-316L
Product Specifi cations:
Model No.
(Part No.)
SS4 EPE-316L
(48087-13)
SS8 EPE-316L
(48087-14)
SS12 EPE-316L
(48087-15)
SS20 EPE-316L
(48088-16)
SS24 EPE-316L
(48089-07)
SS36 EPE-316L
(48089-08)
SS48 EPE-316L
(48089-09)
* Flow rate is based on a maximum velocity of 8ft./sec as required by National Standard Plumbing Code for water piping systems. At a velocity of 10 ft./sec these values can be increased by 25%.
Note: Filter life will be greater with the 25 and 50 micron cartridges. Maximum housing temperature dependant upon maximum cartridge temperature.
Pipe
Size
1-1/2”
NPT Male
2” NPT
Male
2” NPT
Male
2” NPT
Male
3” - 150#
Flange
3” - 150#
Flange
3” - 150#
Flange
Dimensions
Length Diameter AP110 AP124 AP117 APS117 AP420
19-1/2”
(49.5 cm)8”(20.3 cm)
29-1/2”
(74.9 cm)8”(20.3 cm)
39-1/2”
(100.3 cm)8”(20.3 cm)
49-1/2”
(125.7 cm)8”(20.3 cm)
48-1/8”
(122.2 cm)
(147.3 cm)
67-13/16”
(172.2 cm)
(30.5 cm)
58”
(30.5 cm)
(30.5 cm)
12”
12”
12”
Maximum
Pressure
150 psi
(1,034 kPa)
Replacement
Ctg. No.
AP110
AP124
AP117
APS117
AP420
AP110
AP117
AP124
Replacement
Ctg. Qty.
4
8
12
20
24
36
48
32 gpm
(121.1 lpm)
64 gpm
(242.3 lpm)
96 gpm
(363.4 lpm)
160 gpm
(605.7 lpm)
192 gpm
(726.8 lpm)
288 gpm
(1,090 lpm)
384 gpm
(1,454 lpm)
32 gpm
(121.1 lpm)
64 gpm
(242.3 lpm)
96 gpm
(363.4 lpm)
160 gpm
(605.7 lpm)
192 gpm
(726.8 lpm)
288 gpm
(1,090 lpm)
384 gpm
(1,454 lpm)
Flow Rate*
12 gpm
(45.4 lpm)
24 gpm
(90.8 lpm)
36 gpm
(136.3 lpm)
---
---
---
---
12 gpm
(45.4 lpm)
24 gpm
(90.8 lpm)
36 gpm
(136.3 lpm)
32 gpm
(121.1 lpm)
64 gpm
(242.3 lpm)
96 gpm
(363.4 lpm)
Spec #
Quantity
12”
(30.5 cm)
12”
(30.5 cm)
19.5” (49.5 cm)
29.5” (74.9 cm)
SS8 EPE-316L
SS4 EPE-316L
SS12 EPE-316L
Easy Installation:
CAUTION: Diagram shown is for reference purposes
only. Read installation and operation manual prior to
installing the unit.
12”
(30.5 cm)
Model Number
Part Number
Specifi cations:
• 1-1/2” NPT to 3” 150# fl anged pipe size
• System is manufactured from FDA CFR-21 compliant materials
39.5” (100.3 cm)
• System housing has a maximum operating pressure of 150 psi
(1,034 kPa) and operating temperature of 250°F (121°C) [SS4 - SS20],
212°F (100°C) [SS24 - SS48]
SS4 EPE-
316L
AP110
(Qty. 4)
AP124
(Qty. 4)
AP117
(Qty. 4)
APS117
(Qty. 4)
AP420
(Qty. 4)
SS8 EPE-
316L
AP110
(Qty. 8)
AP124
(Qty. 8)
AP117
(Qty. 8)
APS117
(Qty. 8)
AP420
(Qty. 8)
SS12 EPE-
316L
AP110
(Qty. 12)
AP124
(Qty. 12)
AP117
(Qty. 12)
APS117
(Qty. 12)
AP420
(Qty. 12)
SS20 EPE-
316L
AP110
(Qty. 20)
AP124
(Qty. 20)
SS24 EPE-
316L
AP110
(Qty. 24)
AP124
(Qty. 24)
----
----
----
SS36 EPE-
316L
AP110
(Qty. 36)
AP124
(Qty. 36)
SS48 EPE-
316L
AP110
(Qty. 48)
AP124
(Qty. 48)
WARNING: To reduce the risk associated with the ingestion of contaminants: Do
not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
nehctiKmoorhtaB
CAUTION: To reduce the risk associated with property damage due to water leakage:
• Read and follow Use instructions before installation and use of the system.
• Do not install if water pressure exceeds 150 psi (1,034 kPa). If your water pres-
sure exceeds 80 psi (552 kPa), you must install a pressure limiting valve. Contact
a plumbing professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer
conditions exist you must install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this condition.
• The disposable fi lter cartridge MUST be replaced every 6 months, at the rated
capacity, or if a noticeable reduction in fl ow rate occurs.
Public
Water
Supply
Water
Supply
Water Meter
Pressure Tank
Pump
Well
Well
Supply
Only
A
Limited Warranty:
3M Purifi cation Inc. warrants this Product (excluding fi lter cartridge or fi lter membrane) will be free from defects in material and manufacture for the period of ten (10) years from the date
of purchase. The fi lter cartridge or fi lter membrane is warranted to be free from defects in material and manufacture for one (1) year. This warranty does not cover failures resulting from
abuse, misuse, alteration or damage not caused by 3M Purifi cation Inc. or failure to follow installation and use instructions. No warranty is given as to the service life of any fi lter cartridge
or membrane as it will vary with local water conditions and water consumption. 3M PURIFICATION INC. MAKES NO OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OR CONDITION OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR ANY IMPLIED WARRANTY OR
CONDITION ARISING OUT OF A COURSE OF DEALING, CUSTOMER OR USAGE OF TRADE. If the Product fails to satisfy this Limited Warranty during the warranty period, 3M Purifi cation
Inc. will replace the Product or refund your Product purchase price. This warranty does not cover labor. The remedy stated in this paragraph is Customer’s sole remedy and 3M Purifi ca-
tion Inc.’s exclusive obligation. For additional information, see the entire Limited Warranty located in the product Installation and Operating Instruction Manual.
Limitation of Liability. 3M Purifi cation Inc. will not be liable for any loss or damage arising from this 3M Purifi cation Inc. product, whether direct, indirect, special, incidental, or conse-
quential, regardless of the legal theory asserted, including warranty, contract, negligence or strict liability. Some states and countries do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
3M Purifi cation Inc.
400 Research Parkway
Meriden, CT 06450 U.S.A.
Toll Free: 1.800.222.7880
Worldwide: 203.237.5541
Fax: 203.238.8701
www.aquapure.com • www.3Mpurifi cation.com
Distributed by:
Aqua-Pure is a trademark of 3M Company used under license.
3M is a trademark of 3M Company.
© 2011 3M Company. All rights reserved.
70-0201-9321-8 REV 0411
LITAP920
Loading...