Page 1
Installation Guide
August 2015
3M™ Fire Barrier Composite
Sheet CS-195+
Install appropriate 3M™ Fire Barrier product to firestop around
penetrants as needed per system specs.
Mark and pre-drill fastener positions in the Composite Sheet,
ensuring that each fastener is 25mm from each corner and the
maximum spacing between fasteners does not exceed 150mm.
1
Measure the aperture size and cut the 3M™ Fire Barrier Composite
Sheet CS-195+ to size such that it overlaps past the opening 50mm
on each edge. Sheet should be cut to follow the contours of the
penetrants as closely as possible.
3
Apply a bead of sealant or putty on the faces of the floor/wall around
the opening, 25mm from the edges.
2
4
5
Install Composite Sheet over the opening with the steel sheet side
facing out and secure using appropriate fasteners. Seal any joints
between adjacent sheets using a 50mm wide steel cover strip
fastened with steel self-tapping screws and sealant.
For technical support relating to 3M™ Fire Protection Products and Systems, call: 1-800-328-1687
For more information on 3M™ Fire Protection Products, visit: www.3M.com/firestop
Seal any gaps around penetrants using appropriate
3M™ Fire Barrier Sealant or 3M™ Fire Barrier Moldable Putty.
6
Page 2
Installation Guide
This installation guide highlights requirements for 3M™ Fire Barrier Composite Sheet CS-195+ for firestopping general throughpenetration applications. This guide is intended only to highlight general steps or methods and is not intended to describe all details
and requirements. System specifications should comply with local and federal regulations. Examples of system specifiers include UL,
Intertek, and European Technical Approvals and Assessments. Installer should confirm that the field conditions (such as opening size,
pipe size and material, insulation type and thickness, and annular space) comply with the system specifications.
Repair Procedure in Case of Damage
Damaged seals shall be removed and replaced.
Precautionary Information
Refer to product label and Safety Data Sheet for health and safety information before using the product.
For information please contact your local 3M Office. www.3M.com/SDS
Important Notice to User:
Technical Information: The technical information, recommendations and other statements contained in this document are based upon tests or experience
that 3M believes are reliable, but the accuracy or completeness of such information is not guaranteed.
Product Use: Many factors beyond 3M’s control and uniquely within user’s knowledge and control can affect the use and performance of a 3M product in
a particular application. Given the variety of factors that can affect the use and performance of a 3M product, user is solely responsible for evaluating the
3M product and determining whether it is fit for a particular purpose and suitable for user’s method of application.
Warranty and Limited Remedy: 3M warrants that each 3M Fire Protection Product will be free from defects in material and manufacture for 90 days from
the date of purchase from 3M’s authorized distributor. 3M MAKES NO OTHER EXPRESS OR IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If a 3M product does not conform to this warranty, the sole and exclusive remedy is, at
3M’s option, replacement of the 3M product or refund of the purchase price.
Limitation of Liability: Except where prohibited by law, 3M will not be liable for any loss or damage arising from the 3M product, whether direct, indirect,
special, incidental or consequential, regardless of the legal theory asserted.
3M Industrial Adhesives
and Tapes Division
3M Center, Building 225-3S-06
St. Paul, MN 55144-1000
1-800-328-1687
www.3M.com/firestop
3M is a trademark of 3M Company. © 3M 2015. All rights reserved.
Loading...