3M BEV145 User Manual
3M™ Water Filtration Products
SPEC#
QUANTITY
Pre-Activated
“IMPACT”
Integrated Membrane
model:
application:
COLD BEVERAGE
BEV140/BEV145
3M™ Water Filtration Products, High Flow Series models BEV140 and BEV145 single
cartridge water filtration systems help to improve the taste, appearance and
consistency of your beverages at flow rates up to 2.1 gpm (7.9 lpm).
BEV140 combines cyst and bacteria1 reduction with particulate and chlorine taste and
odor reduction for up to 25,000 gallons (94,635 liters).
BEV145 combines particulate reduction with chlorine taste and odor reduction for up to
25,000 gallons (94,635 liters).
PRODUCT BENEFITS
• Consistent high-quality, great tasting beverages for continued customer satisfaction.
• Revolutionary Integrated Membrane Pre-Activated Carbon Technology (“I.M.P.A.C.T”)
dual-zone media cartridge construction combines a membrane in series with
premium activated carbon to provide superior throughput and cartridge life.
• Built-in bacteria inhibitor intended to reduce fouling of media. (HF40 replacement
cartridge).
• Certified by NSF to Standard 53 for cyst reduction (HF40 replacement cartridge).
• NSF Standard 42.
• FDA CFR-21 compliant materials.
• NSF Certified 3M Purification Inc. (High Flow Series).
• Reduction of up to 99.99% of common water-borne bacteria by membrane filtration
as tested by 3M Purification Inc. (HF40 replacement cartridge).
• Reduction of particulate helps prevent equipment wear and helps extend the life of
pumps, valves, o-rings and seals.
• Valve-in-head design simultaneously shuts off and vents water, allowing for simple
Carbon Technology
and virtually trouble-free cartridge change-outs without the need to shut off the
upstream feed water.
• Sanitary Quick Change (SQC) encapsulated cartridge design allows for fast and easy
cartridge change-outs with a 1/4 turn.
• 3/8" FNPT horizontal inlet and outlet ports allow direct or easily adaptable
connections to existing plumbing lines.
PRODUCT SPECIFICATIONS
Model
Number
BEV140 5616201
BEV145 5616202
Part
Number
Reduction
Claims
Cyst, Bacteria1,
Particulate, Chlorine
Taste and Odor
Particulate, Chlorine
Taste and Odor
Nominal
Micron
Rating
2
0.2
2
3.0
Capacity
25,000 gallons
(94,635 liters)
25,000 gallons
(94,635 liters)
1
As tested and verified with either E. Coli ATCC (11229) by manufacturer’s lab.
2
NSF Certified for Particulate Class I
Service
Flow Rate
2.1 gpm
(7.9 lpm)
2.1 gpm
(7.9 lpm)
Application
Most Standard
Water
Higher
Turbidity Water
Replacement
Cartridge
HF40:
5613303
HF45:
5613307
Sizing
Single High Flow
Carbonator
Dispenser
Single High Flow
Carbonator
Dispenser
BEV140/BEV145
SPEC#
QUANTITY
MODEL NUMBER
PART NUMBER
3M
Water Filtration Products
™
SPECIFICATIONS
• System includes a head assembly with integral mounting bracket, pressure gauge and a
single cartridge filter.
• Inlet and outlet plumbing connections are 3/8” FNPT.
• System incorporates an internal automatic 1/4 turn shut-off valve.
• Filter cartridges are O-ring seal type.
• System maximum operating pressure of 125 psi (862 kPa) and operating temperature of
100 °F (37.8 °C).
• Recommended service flow rate is up to 2.1 gpm (7.9 lpm).
• Filter cartridges incorporate a bacteriostatic carbon block filtration medium (HF40
replacement cartridge).
• NSF Standard 42.
• FDA CFR-21 compliant materials.
• Cartridges are sanitary in design, requiring no contact with the filter media during
cartridge change-out.
• Filter cartridges require no pre-activation.
• NSF Performance Data Sheet (PDS) is included.
• Shipping weight: 8.9 lbs. (4.0 kg) per case.
• Operating weight: 6 lbs. (2.7 kg) per case.
• Case quantity: 2.
IMPORTANT: INSTALLATION TIPS
3
IMPORTANT: INSTALLATION TIPS
These installation tips are for informational purposes only and are not intended to be used
as actual installation instructions. CAUTION: To reduce the risk associated with property
damage due to water leakage:
WARNING: To reduce the risk associated with the ingestion of
contaminants:
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts. EPA Establishment
#10350-MN-007
3M Purification Inc. recommends regularly scheduled maintenance and
replacement of the filter cartridge(s) in order for the product to perform as
advertised/sold. 3M Purification Inc. shall not be liable for system failures
due to improper maintenance.
•Read and follow Use Instructions before installation and use of this system.
•InstallationanduseMUST comply with all state and local plumbing codes.
•Protect from freezing, remove filter cartridge when temperatures are expected to drop
below 40°F (4.4°C).
•Do not install on hot water supply lines. The maximum operating water temperature of
this filter system is 100°F (37.8°C).
•Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure ex-
ceeds 80 psi (552 kPa), you must install a pressure limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
•Do not install where water hammer conditions may occur. If water hammer conditions exist
you must install a water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.
•ThedisposableltercartridgeMUST be replaced every 12 months, at the rated capacity
LIMITED WARRANTY
3M Purification Inc. warrants this Product will be free from defects in material and manufacture for five (5) years from the date of purchase: The filter cartridge or filter membrane is
warranted to be free from defects in material and manufacture for one (1) year. This warranty does not cover failures resulting from abuse, misuse, alteration or damage not caused
by 3M Purification Inc. or failure to follow installation and use instructions. No warranty is given as to the service life of any filter cartridge or membrane as it will vary with local
water conditions and water consumption. 3M PURIFICATION INC. MAKES NO OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO,
ANY IMPLIED WARRANTY OR CONDITION OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR ANY IMPLIED WARRANTY OR CONDITION ARISING OUT OF A
COURSE OF DEALING, CUSTOMER OR USAGE OF TRADE. If the Product fails to satisfy this Limited Warranty during the warranty period, 3M Purification Inc. will replace the Product
or refund your Product purchase price. This warranty does not cover labor. The remedy stated in this paragraph is Customer’s sole remedy and 3M Purification Inc.’s exclusive
obligation. For additional information, see the entire Limited Warranty located in the product Installation and Operating Instruction Manual.
Limitation of Liability: 3M Purification Inc. will not be liable for any loss or damage arising from this 3M Purification Inc. product, whether direct, indirect, special, incidental, or
consequential, regardless of the legal theory asserted, including warranty, contract, negligence or strict liability. Some states and countries do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you.
or sooner if a noticeable reduction in flow rate occurs.
3M Purification Inc.
400 Research Parkway
Meriden, CT 06450, U.S.A.
Tel 1-866-990-9785
1-203-237-5541
Fax 1-203-238-8701
www.3Mfoodservice.com
www.3Mpurification.com
Visit www.nsf.org for
the claims associated
with products that
are NSF listed.
Please recycle. Printed in U.S.A.
3M is a trademark of 3M Company.
NSF is a trademark of NSF International.
© 2013 3M Company. All rights reserved.
70020194125 REV 0413
Loading...