32 Degrees Rebel Deluxe User Manual

Operation Guide

Safety

Play Safe

Instruction Manual

Congratulations on your purchase of the 32 Degrees
Rebel Deluxe semi-auto. Before you use this marker,
please read this manual in its entirety. Please follow all
safety instructions as described in this manual.

Warning

This paintball marker is not a toy. Misuse or mishandling can
result in serious injury or death. The RebelDeluxe is to be
used by adults 18 years of age or older,or under the direct
supervision of an adult. Please follow all local, state, and fed ­eral laws concerning paintball markers and playing paintball.
By purchasing this marker you assume all liability. 32 Degrees
accepts no liability for injury or death due to misuse
or mishandling of this marker.

Rebel Specifications

Model Rebel Deluxe Semi-Auto
Caliber .68
Action Blow Back Semi-Auto
Power C02 or Compressed air
Cycle Rate Up to 6 balls per second
Effective Range 150+ feet
Length 16.5 inches
Height 10.5 inches

1. Never point a paintball marker at anyone
not wearing paintball approved goggles. Even at the
lowest possible operating velocity, a paintball will
cause serious injury should it hit someone in the eye
area.

2. Never look down the barrel of your marker
with or without wearing paintball approved goggles.

3. Always disconnect your air-source and dry
fire the marker before working on or cleaning it.
Always have a qualified air smith do repairs or
modifications to your Rebel Deluxe.

4. Always leave the Rebel Deluxe uncocked and turn
the power feed plug to the “off” position.

5. Only play at
commercial playing fields that
have a chronograph, referees
and clearly marked safe fields.
Chronograph your marker
before each game to ensure
your gun is operating at safe
velocities. Safe velocities are
considered to be below 280
feet per second.

Always wear

Paintball Approved

Goggles

Getting Started

General Description and Basic Use Instructions
Included with your Rebel Deluxe semi-auto should be the
following items:

maintenance

Now that the goggles are on make sure your marker is in
the cocked position. Install the C02 tank and your Rebel
Deluxe is ready to fire. Make sure you chronograph your
marker before you use it. Like any other paint marker,
maintenance is the key to keeping the Rebel Deluxe
shooting consistently. This chapter is a basic overview of
what it takes to keep the Rebel functioning properly.

• Rebel Deluxe Semi-Auto

• Barrel

• Low Pressure Chamber

• Packet with o-rings, velocity thumb
screw, and allen wrench

• Separate Allen wrench

The 32 Degrees Rebel Deluxe is almost ready to use out
of the box. All that is needed is a C02 tank, paintballs,
and a feeder, and then you are ready use your marker.
First screw in your barrel (hand tight). Now that your
barrel is in, insert the barrel plug into the front of the
barrel. With your barrel plug in, you are ready to work on
your marker. Next push the safety in the “safe” position
and attach your feeder elbow and feeder to the power
feed tube. Turn the power feed plug so that it does not
allow paintballs to enter the chamber. Screw the low
pressure chamber into the front end of the marker, just
below the barrel. Now that you have everything
connected you are ready to gas up the gun. Before you
gas up the marker you should always wear paintball
approved goggles.

Lubrication: To keep your Rebel Deluxe internal

components operating smoothly, place about four
drops of oil in your gun’s C02 adapter and dry fire the
gun (after removing the barrel). This will spread the
oil throughout the gun. After cleaning your Rebel Deluxe
internally, lube the hammer/push strut assembly as
well--be careful not to over-oil this area.

Warning: Some petroleum based oils can damage

your gun’s o-rings. Use only oil manufactured
specifically for paintball markers.If you expect any degree
of consistency from your Rebel Deluxe, you must keep it
clean internally and externally. The two external areas
you’ll need to be the most careful with are the power
feed/feed tube and the barrel. If you break a ball in the
barrel, you will lose most of your accuracy until you clean
it completely. On the field, remove the barrel and run a
pull-through squeegee through it. For a more complete
cleaning (off the field) you’ll need to clean the barrel
with warm water or barrel cleaner/treatment and
squeegee it until it is dry. A pull-through squeegee can
also be used to clean the power feed once the plug
is removed.