Targus 402-0145-001B User Manual

121.54 Kb


Operating Instructions

The plug-and-playUltra Mini Optical Mouse requires no driver or software.

To extend the USB cord, hold the mouse in one hand and the USB connector in the other. Pull both ends of the cord away from the cord wheel at the same time.

To retract the USB cord, extend both ends of the cord slightly and release quickly.

When the ideal length of USB cord is fixed, plug the mouse USB connector into your PC's USB port and you are ready to go.

Technical Support

For technical questions, please visit:


Internet: http://www.targus.com/support.asp


Internet : www.targus.com.au

Email : infoaust@targus.com

Phone: 1800-641-645

New Zealand


Monday through Friday, 8:30 a.m. (08:30) to 5:30 p.m. (17:30): 0800-633-222

Product Registration

Targus recommends that you register your Targus accessory shortly after purchasing it.

To register your Targus accessory, go to: http://www.targus.com/registration.asp

You will need to provide your full name, email address, phone number, and company information (if applicable).


Targus warrants this product to be free from defects in materials and workmanship for one year. If your Targus accessory is found to be defective within that time, we will promptly repair or replace it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage to a computer; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental damages, even if Targus has been informed of their possibility. This warranty does not affect your statutory rights.

Warranty Registration at: http://www.targus.com/registration.asp

Regulatory Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Statement

Tested to comply

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna;

Increase the separation between the equipment and receiver;

Move the computer away from the receiver;

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Features and specifications subject to change without notice. All trademarks and registered trademarks are the property of their respective owners. © 2004, All Rights Reserved, Targus Group International and Targus, Inc., Anaheim, CA 92806 USA