Cisco Systems IGX 8410 User Manual

Size:
18.1 Kb
Download

About This Guide

This section discusses the objectives, audience, organization, and conventions of the Cisco IGX 8400 Series Installation publication.

Cisco documentation and additional literature are available in a CD-ROMpackage, which ships with the product. The DocumentationCD-ROMis updated monthly. Therefore, it might be moreup-to-datethan printed documentation. To order additional copies of the DocumentationCD-ROM,contact your local sales representative or call customer service. TheCD-ROMpackage is available as a single package or as an annual subscription. You can also access Cisco documentation on the World Wide Web at http://www.cisco.com,http://www-china.cisco.com,orhttp://www-europe.cisco.com.

Objectives

This publication provides descriptions for installing and starting up the following IGX hardware:

Enclosures

Power sources (AC and DC)

Controller cards (the CPU for the node)

Frame relay interface cards

Voice interface cards

Serial data interface cards

ATM interface cards

Trunk cards

Alarm cards

Audience

The Cisco IGX 8400 Series Installation publication provides installers, operators, and network designers and managers with the necessary understanding to set up any model of an IGX node. This manual applies to the IGX 8410, IGX 8420, and IGX 8430 nodes in bothrack-mountandstand-aloneversions.

xiii

Organization

The major sections of this publication are as follows:

Chapter 1, “Introduction”

Chapter 2, “Enclosure and Power Installation”

Chapter 3, “Card Installation and Node Startup”

Chapter 4, “Troubleshooting”

Chapter 5, “Repair and Replacement”

Chapter 6, “Upgrading Rack-Mounted Nodes”

Appendix A, “System Specifications”

Appendix B, “Peripherals Specifications”

Appendix C, “Cabling Summary”

Appendix D, “Cisco Cabinet Dimensions”

Conventions

This publication uses the following conventions to convey instructions and information.

Command descriptions use these conventions:

Commands and keywords are in boldface.

Arguments for which you supply values are in italics.

Required command arguments are inside angle brackets (< >).

Optional command arguments are in square brackets ([ ]).

Alternative keywords are separated by vertical bars ( | ). Examples use these conventions:

Terminal sessions and information the system displays are in screen font.

Information you enter is in boldface screen font.

Nonprinting characters, such as passwords, are in angle brackets (< >).

Default responses to system prompts are in square brackets ([ ]).

Note Meansreader take note. Notes contain helpful suggestions or references to materials not contained in this manual.

Caution Meansreader be careful. In this situation, you might do something that could result in equipment damage or loss of data.

xiv Cisco IGX 8400 Series Installation, Release 8.2.5

Warning This warning symbol meansdanger. You are in a situation that could cause bodily injury. Before you work on any equipment, you must be aware of the hazards involved with electrical circuitry and familiar with standard practices for preventing accidents. (To see translated versions of this warning, refer to theRegulatory Compliance and Safety Information document that accompanied the product.)

xv

xvi Cisco IGX 8400 Series Installation, Release 8.2.5