
Multipress
automatic
MP 80
Type 4290
Automatic Juice Extractor
English
Use Instructions
4-290-382/00/VIII-06
Korea/GB

English
Caution
●
Read all instructions carefully before
using this product.
●
This product is suitable for normal household
use only and not for commercial use.
●
Keep out of children’s reach.
●
Do not reach into the filling shaft while the
motor is running. Always use the pusher to
guide food through the shaft.
●
Remove plug from socket before assembling
or disassembling appliance.
●
Braun electric appliances meet applicable
safety standards. Repairs or the replacement
of the mains cord must only be done by
authorised service personnel. Faulty,
unqualified repair work may cause
considerable hazards to the user.
Specifications
●
Voltage/wattage: See typeplate on the
bottom of the appliance.
●
Safety system: The appliance can only be
switched on when the cover has been fully
locked into position and can only be opened
when the switch has been turned off.
●
Motor stop: The motor will stop completely
within 2 seconds of switching the appliance
off.
Safety fuse
If the appliance is overloaded the safety fuse
will cut out. To restart the appliance:
Turn the switch 2 off = «0» (important!).
●
●
Unlock and remove the cover
Clean the juice ring 5, filter 6 and cover 7.
●
●
Allow the appliance to cool down approx.
20 minutes.
●
Assemble the juicer again.
Turn the switch 2 on = «l».
●
●
If the appliance still does not run, allow it
to cool down again.
7
.
q
Juice spout
l
Juice container with foam separator
m
Cord storage
Before using for the first time, wash the juicer
parts (see «Disassembling» and «Cleaning»).
Assembling
1. Put the juice ring 5 on the motor part 1
(fits loosely without engaging).
2. Lay the filter
3. Put the cover
with both hands until you hear it snap into
place.
4. Hang the pulp container
(the top one first); then close it and be sure it
snaps into place.
5. Put the juice container
juice spout
container comes with a foam separator to
ensure clear foam free juice.
If it is not required simply remove it from the
juice container. You can, of course, place a
glass or other container underneath the juice
spout to collect the juice.
6. For easier filling, put the filling tray
of the filling shaft
Preparing fruit or vegetables
Important: Use only well ripened fruits, otherwise the filter
would result in repeated cleaning of the filter.
Wash or peel the fruit or vegetables you want
to process. Fruit with large pips or stones
should always have these removed first. Process seed fruit (such as apples, pears) with
peels and cores. Fruit and vegetables with thick
peels (e. g. citrus fruits, melons, kiwis, beets)
must be peeled first. For grapes, cut off the
main stem. For leaf vegetables (e. g. cabbage
and spinach) and herbs, roll up leaves together
tightly. Cut fruit and vegetables into pieces
large enough to fit into the filling shaft.
6
into the juice ring 5.
7
on and push down firmly
4
onto the hinges
l
8
(A).
underneath the
9
on top
q
(A). Capacity: 500 ml. The juice
6
may be clogged up which
Description
1
Motor part
On/off switch
2
3
Unlocking buttons
4
Pulp container
5
Juice ring
6
Filter
7
Cover
8
Filling shaft
9
Filling tray
j
Pusher
Currants and rhubarb are not
making juice in the Braun Multipress.
Extracting juice
Put fruit or vegetables into the filling shaft
●
Turn the switch 2
with the pusher
vegetables while the motor is running.
The amount of juice you extract depends on
●
the nature of the fruits and vegetables. When
j
suitable for
on = «I» and press lightly
(A). Add further fruits or
8.

processing berries the quantity of juice will
be smaller, because of their high amount of
pectin (pectin is a natural gelatine).
(Special berry presses or steam presses are
better suited to that type of fruit.)
●
Fruit and vegetable juices contain valuable
vitamins and minerals, which quickly
deteriorate when they come into contact with
oxygen or light. Drink juice fresh – right after
it has been extracted.
Im
portant: The filter ist not dishwasherproof,
but can easily be cleaned with a small brush.
Do not use a damaged filter. We recommend
to replace the filter after 5 years (available
at Braun Service Centres).
For space-saving storage, place the filling
tray
9
upside down on top of the juicer.
Subject to change without notice.
Emptying the pulp container 4 and filter
You can extract juice continuously until the
pulp container is full:
●
When processing produce with high liquid
content (e. g. tomatoes, grapes, melons):
Do not process more than 3 kg of fruit or
vegetables before emptying the pulp
container.
●
When processing drier produce (e. g. carrots, pears, apples):
Empty the pulp container as soon as it
looks full.
If the juice suddenly becomes much thicker
or if you can hear the motor speed slow
down, the filter must be emptied (see «Disassembling»).
Empty the pulp and put the appliance together
again.
Disassembling
1. Turn the switch 2 off = «0».
2. Remove the pusher
9
. Swing open the pulp container
tray
push it up and pull off downward diagonally
(B). (When replacing the pulp container,
insert the top first.)
3. Press the unlocking buttons
of the juicer (C), to unlock the cover
Remove the cover.
4. Remove the juice ring
filter
6
. Take the filter out of the juice ring.
j
. Remove the filling
3
on both sides
5
together with the
6
4
,
7
.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
Please do not dispose of the product in
the household waste at the end of its
useful life. Disposal can take place at
Braun Service Centre or at appropriate
collection points provided in your country.
Cleaning
Always remove the plug from the socket first!
●
●
Clean the motor part 1 with a damp cloth
only – never immerse it in water.
All other plastic parts can be washed in a
dishwasher or using warm water and normal
dishwashing liquids. The plastic parts may
discolour when processing food with a high
pigment content (e. g. carrots):
Use vegetable oil to clean before using the
dishwasher.