1
P-M-O
Wireless Home Automation
Power Meter Outlet
SPECIFICATIONS
Model Number: RPB11647BSB
Z-Wave Signal Frequency: KR (920.9MHz, 921.7MHz, 923.1MHz)
Power: 220V, 60Hz
Maximum Load: 16A, 3200W
Range: Up to 100 feet line of sight
Operating Temperature: -10 ~ 40oc
Product Type: Receptacle
Dimensions: 92 x 156 x 62 (mm)
FEATURES
Basic solution for wireless home automation that replaces regular receptacles
220V up to 16 Amp endurance
Measures energy consumption of home appliance
Manual remote switching ON/OFF function
DESCRIPTION
P-M-O is a Power Meter Outlet that can control On / Off remotely.
You can completely replace your regular outlet.
You can connect home appliances such as home lamps, TVs, and others.
P-M-O is Z-Wave certified device, and it is fully interoperable.
You can view power and power usage in your Z-Wave controller or your apps.
The power status can be remotely controlled, and the LED indication changes according
to the power status.
The built-in relay is basically connected-on state.
It is very efficient to remotely control power and monitor the amount of power used.
2
WARNINGS AND CAUTIONS
Switch the main power off when installing Z-wave products.
Do not exceed current 16 Amp at all times.
Do not disassemble the outlet.
Switches are not guaranteed to remotely operate in certain circumstances such as radio
shadow area.
Z-wave enabled devices should never be used to supply power to, or control the On/Off
status of medical and/or life support equipment.
Do not install the products outdoors and/or humid environment
INSTALLATION
A
Holl for Push Button
E
Wall Connection screw hole
B
Push Button
F
Hot (red)
C
LED indicator
G
Neutral (black)
D
Case coupling hole
H
Ground (green)
1. Shut off power to the circuit at circuit breaker or fuse box.
※ Warning: Verify power is OFF to switch box before continuing.
2. Remove wall plate.
3. Remove the outlet mounting screws.
4. Carefully remove the outlet from the outlet box
5. Disconnect the wires from the existing outlet.
6. There are three wires on the P-M-O. Match these to the wires on wall.
7. Fix the P-M-O to the wall and fasten the screw.
8. Place the case on the product.
Loading...