Z-Wave HKZW-STICK Operating Manual

Power supply:

DC 4.75~5.25V

12.71mm

72.39mm

OPERATING MANUAL

STICK

HKZW-STICK - V1.0

The Stick is a USB v2.0 full speed low power CDC-ACM compliant Z-Wave adapter in a
thumb drive form factor. The Stick can act as a Z-Wave Controller when it’s connected to a
host like PC, MAC or Gateway (some in the market) etc. With a certain program installed on
the PC, it can add or remove devices in or from a network.

Ⅰ. GENERAL INFORMATION ABOUT STICK

1. Product layout

2. Specifications

Storage environment:

-20℃~60℃ 0%~80%

Operational temperature:

-10℃~40℃
Radio protocol:

Z-Wave Plus

Radio frequency:

868.42 MHz (EU)

908.42 MHz (US)

921.42 MHz (ANZ)

Range:

More than 150m outdoors
About 40m indoors (depending
on building materials)

Dimensions:

90*25*11mm

Ⅱ. INSTALLATION

The stick can act as a secondary controller within an existing Z-Wave network after the
terminal program being installed. You can also use the stick to make a new Z-Wave network.
As the device exports a USB CDC/ACM class compliant interface, it appears as a serial port,
reusing existing standard drivers on most popular PC operating systems. As such there is no
vendor driver required.

1. Windows 2000/XP/Vista/7/8 32 & 64 bit
UZB.INF & UZB.CAT are provided in the Z-Wave SDK that reuses the standard Windows
usbser.sys or usbser64.sys driver. The device appears in the Device Manager under the
Ports section, and is accessible through the Windows CreateFile API by applications as
“//.//COMxxx” where xxx is the COM Port number assigned by the OS.

2. Linux kernel 2.6.24+
The device appears as “/dev/ttyACMxx” where xxx is the tty number assigned by the OS.

3. MAC OS X 6.4
The device appears as “/dev/tty.usbmodemxxx” where xxx is the tty number assigned by
the OS.

Ⅲ.INDICATOR

4. The LED indicator on the Stick will keep being on when it’s successfully connected to the
host.

5. The LED Indicator will blink once when the stick is sending a Z-Wave command.

Ⅳ. INCLUSION AND EXCLUSION / LEARN MODE

1. Stick can add or remove any Z-Wave devices.

2. Plug the stick into the PC’s USB port, start PC Controller and then it can add or remove Z­Wave devices.

V. ASSOCIATION COMMAND

Grouping
Identifier

Max
Nodes

Send Commands
Group 1

0xE8

COMMAND_CLASS_ZWAVEPLUS_INFO

V2

COMMAND_CLASS_SECURITY

V1

COMMAND_CLASS_SECURITY_2

V1

COMMAND_CLASS_TRANSPORT_SERVICE

V2

COMMAND_CLASS_VERSION

V2

COMMAND_CLASS_MANUFACTURER_SPECIFIC

V2

COMMAND_CLASS_POWERLEVEL

V1

COMMAND_CLASS_APPLICATION_STATUS

V1

COMMAND_CLASS_ASSOCIATION

V2

COMMAND_CLASS_ASSOCIATION_GRP_INFO

V1

COMMAND_CLASS_CONFIGURATION

V1

COMMAND_CLASS_CRC_16_ENCAP

V1

COMMAND_CLASS_SUPERVISION

V2

COMMAND_CLASS_INCLUSION_CONTROLLER

V1

Ⅵ. Factory Default Reset

It happens automatically when the device is excluded.

Ⅶ .Security features

Default node info frame:

The NIF can be modified in PC Controller.