Your Current TV Remote Can Control Your SB400/SB500.
After following the steps outlined in this guide, your cable or satellite
remote will adjust the volume output from your soundbar system. Please
Note: If you have a DirecTV remote control, use the DirecTV remote
guide included along with this instruction sheet.
The steps involve pressing the Volume, Mute, and Power buttons of your
preferred remote control with the remote positioned close to the numeric
display of the soundbar. Once complete, the soundbar will respond to
the buttons it has learned from your preferred remote control.
PREPARE
To insure accuracy, the learning routine records each button’s
commands twice, then conrms a successful button learning.
ZVOX® Audio has specic instruction sets available for a variety of
popular remote controls. These instructions provide an alternate method
for conguring your SB400/SB500 to respond to your preferred remote
control. If you cannot easily teach the SB400/SB500 to respond to your
preferred remote control, please contact ZVOX Audio about additional
instructions for your preferred remote control.
1 2 3
Stand or sit within easy reach
of the soundbar’s control buttons
(the end on your right hand side).
You will need to press two buttons on
the SB400/SB500 end panel to start the
learning process. Then you will press four
buttons on your preferred remote control.
Locate the following
buttons on your
remote control:
1
VOLUME UP
2
VOLUME DOWN
3
MUTE
4
POWER
The learning process
involves pressing these
four buttons in sequence.
This remote is only an example. Your
remote is probably different. Please
locate these buttons on your remote.
4
3
1
2
Press both
VOLUME buttons
on the soundbar
until “Lrn” appears
(about 4 seconds).
Then release both
VOLUME buttons.
• Get ready
to press
VOLUME UP
on the Remote
Control.
Error Message of
the SB400/SB500
Learning Routine
volume up volume down
1 2 3 4
When appears, press
VOLUME UP for 1 second.
You should see .
When appears, press
VOLUME UP for 1 second, again.
If you see the “no change” message (nocH) during the learning routine,
the SB400/SB500 system system did not accept the infrared code.
The current step in the learning routine will repeat.
LEARN BUTTONS
When appears, press
VOLUME DOWN for 1 second.
You should see .
When appears, press
VOLUME DOWN for 1 second, again.
mute
When appears, press
MUTE for 1 second.
You should see .
When appears, press
MUTE for 1 second, again.
power
When appears,press
POWER for 1 second.
You should see .
When appears, press
POWER for 1 second, again.
You should see ,
followed by .
You should see ,
followed by .
YOU ARE DONE!
You should see ,
followed by .
You should see ,
followed by .
© 2015 ZVOX Audio LLC.
Loading...