Zvox 570, 870, 770, 670, 450 User Manual

MUTE VOLUME INPUT

This guide applies to the SoundBase models 350, 450, 570, 670, 770 and 870.

It does not apply to the SoundBase 220, 320, 420, 555 and 580

and earlier ZVOX Audio products.

ZVOX SoundBase® Adjustment Options

The PS Menu

The SoundBase has a variety of function
and sound adjustments that could prove
useful depending on the SoundBase
owner’s installation and usage preference.
The list of adjustments is called the
PS Menu.

If your TV set does not have a “internal
speakers off” feature or if your TV displays
a distracting “TV speakers off” message,
the PS menu allows you to adjust the
SoundBase and your preferred remote
control so that the volume buttons on your
preferred remote control adjust the sound
just from the SoundBase and not the TV.

These adjustments are made using the four
front panel buttons on a SoundBase while
watching the LED display. The SoundBase
remote control cannot make adjustments to
the PS Menu.

Adjusting the PS Menu

To make a selection from the PS menu listing,
press and hold down both the MUTE and
VOLUME UP front panel buttons for about 3
seconds. If this is the rst time you have used
the PS menu, you will see the characters
“PS-0” start ashing. Immediately release the
two buttons when you see the PS number
ashing. Then quickly press and release
the Volume Up button while “PS” is still
ashing. This will increase PS number setting.
Pressing Volume Down will decrease the PS
number setting, down to “PS-0”. Each time
you press the Volume Up or Volume Down
button, you have an additional six seconds to
make an adjustment.

Once you arrive at your intended PS number,
just wait for the display to stop ashing the
PS number. When the ashing stops, the
adjustment is made.

Press both buttons for three or
more seconds to trigger the PS
number adjustment mode.

While ashing, the Volume Up or Down
buttons set the PS number. After adjustment,
the setting is stored when the display turns off.

®

[phone] | [e-mail]

PS Emulation Modes

The rst six options in the PS menu are emulation modes. See “Using the SoundBase remote
control emulation modes” for instructions.

No brand

Sony LG

Samsung

Vizio

Panasonic

emulation

There are no PS number choices between PS 6 and PS10.

Additional PS Settings

Additional SoundBase adjustments affect how you turn the SoundBase on and off and how it
responds to remotes

“AS” Auto Standby:

When PS10 is selected, the SoundBase will
automatically enter a low-power draw Standby
mode after 20-30 minutes of very low to no audio
signal. In most uses, this means the SoundBase
will turn its self off after you turn off the TV.

“noAS” no Auto Standby:

When PS11 is selected, the SoundBase will
only enter Standby in response to a press of the
POWER button on the SoundBase remote or
from a “learned” remote control. The SoundBase
will not enter Standby automatically.

“AO” Auto On:

The SoundBase turns on in response to
the Power, Volume and Mute commands
from the SoundBase remote and from
the “learned” remote.

“noAO” no Auto On:

The SoundBase turns on in response to a
SoundBase remote command, but not a
“learned” remote command. Once on, the
SoundBase will respond to a “learned” remote.

Marantz

“OnEr” One Remote:

The SoundBase responds to just the
SoundBase remote control. Any “learned”
remote response is disabled. Choosing PS12
or PS13 restores a “learned” remote’s ability
to control the SoundBase.