ZTE AC2746 Users Manual

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

CDMA2000 1X EV-DO Wireless Data Terminal

User Guide

This User Guide is used for Wireless Data Terminal of AC2746.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

No part of this publication may be excerpted, reproduced, translated or utilized in any form or by

any means, electronic or mechanical, including photocopying and microfilm, without the prior

written permission of ZTE Corporation.

ZTE Corporation reserves the right to make modifications on print errors or update specifications

in this manual without prior notice.

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

Table of Contents

1. Introduction................................................................................................................................... 1

2. Precautions .................................................................................................................................... 1

3. Appearance.................................................................................................................................... 2

3.1 Introduction ............................................................................................................................... 2

3.2 Insert R-UIM Card.................................................................................................................... 2

3.3 Operation Guide of Data Cable ...............................................................................................3

4. Install and Uninstall...................................................................................................................... 3

4.1 System Requirements ............................................................................................................... 3

4.2 Installation Guide..................................................................................................................... 3

4.2.1 Install .............................................................................................................................. 3

4.2.2 Uninstall ......................................................................................................................... 4

5. Run the Application ...................................................................................................................... 4

6. Connect/Disconnect ...................................................................................................................... 5

7. Connection Records...................................................................................................................... 5

8. Voice Call ......................................................................................................................................... 6

9. Call History ...................................................................................................................................... 7

10. Short Message................................................................................................................................ 8

11. Phone Book .................................................................................................................................... 9

12. Setting........................................................................................................................................... 10

13. Help............................................................................................................................................... 12

14. FCC Regulations.......................................................................................................................... 13

15. RF Exposure Information (SAR)................................................................................................14

16. Trouble-shooting.......................................................................................................................... 15

ZTE Corporation http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

1. Introduction

Thank you for choosing ZTE Corporation’s CDMA2000 Wireless Data Terminal (hereinafter referred to as Data Terminal).

Data Terminal supports both CDMA2000 1X EV-DO and CDMA2000 1X network. In the area where there is signal, it allows you to go surfing on the Internet, send & receive short messages, and make & receive phone calls.

The pictures in this help are only used to demonstrate your Data Terminal’s functions, so they are maybe different from what you see on your Data Terminal. Please refer to your Data Terminal if they are differences.

2. Precautions

z Use the original accessories or those authenticated by the manufacturer. Using any

unauthenticated accessories may affect the data terminal’s performance, violate the warranty

provisions or relevant national regulations about telecom terminals, or even cause body

injury.

z Do not disassemble, modify, frequently pull/plug the antenna, stretch, rotate or bend the

antenna with great force.

z Before pulling out the data terminal, please use Windows safely removing the hardware and

make sure to exit the application. Do not directly pull out the terminal to avoid the damage of

data terminal or the influence on the normal operation of operating system.

z Do not forcefully plug/pull the data terminal to avoid the damage of connector. z Do not use your data terminal near weak signal or high-precision electronic devices. Radio

wave interference ma y cause misoperation of electronic devices or other problems.

z Turn off your data terminal on airplane where it’s forbidden to use it. The data terminal may

affect the normal operation of electronic devices, therefore please follow the relevant

regulations when using your mobile phone on airplane.

z Turn off your data terminal in hospital where it’s forbidden to use it. The data terminal may

affect the normal operation of medical apparatus, therefore please follow the relevant

regulations when using your mobile phone in hospital.

z Please do not use the data ter minal near flammable or explosive materials; otherwise it might

cause failure or fire.

z Keep your data terminal away from water. This may cause overheating or failure if water or

any other kind of liquid enters your mobile phone. Please do not use your data terminal near

high temperature, damp or dusty place.

z Keep your data terminal away from chil dren to avoid shock, plunge or impact. It may cause

body injury when the data terminal is used as a toy.

ZTE Corporation 1 http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

3. Appearance

3.1 Introduction

Side Vie

Antenna

Jack

Rear Vie

Cap

USB Interface

Back Cover

3.2 Insert R-UIM Card

Note: If your data terminal doesn’t need R-UIM card, please skip this section.

1. Pull out the tap；

2. Take out the R-UIM card cover in the direction indicated by the arrow；

3. Insert R-UIM card as below figure；

4. Push back R-UIM card cover.

ZTE Corporation 2 http://www.zte.com.cn

CDMA2000 1X EV-DO Wireless Data Terminal User Guide

3.3 Operation Guide of Data Cable

Generally, the Data Terminal could be directly connected with USB port. You could also connect

the Data Terminal with PC by using the accompanying data cable, as shown in the following figure. Connect Interface ① with Data Terminal, and interface ② with PC's USB port. If the power supply from USB port is insufficient, connect both interfa ce ② and ③ wit h USB port

together.

4. Install and Uninstall

4.1 System Requirements

The Data Terminal supports the following operating system:

¾ Windows 2000

¾ Windows XP

¾ Windows Vista

PC minimum configurations:

CPU Pentium-II/233MHz

USB interface 2.0 (USB1.0 and 1.1 compatible)

Optical Drive CD-ROM (for installation only)

Memory 64 MB

Disk Space 50 MB (used for installation of application)

4.2 Installation Guide

4.2.1 Install

1. Please connect Data Terminal to PC through USB interface. You could use t he data cable to

connect.

2. The installation driver will automatically run. Please install according to the installation wizard.

3. The system will automatically find new hardware and install the driver. Wait for a while. Click

"Finish" after the installation is completed.

ZTE Corporation 3 http://www.zte.com.cn

+ 13 hidden pages