Assembly Instructions
Caution : You must read this before you proceed
OTTOMAN
Page 1 OF 4
Label Picture Description QTY
A Ottoman Body 1
B Leg 4
Label Picture Description QTY
①
Plastic Washer 7
Hardware
Assembly Preparation
Assembly Steps
Before
Beginning
Assembly:
OVERVIEW
Parts List
FRONT FACING
X1
X4
X7
Leg(B)
Ottoman Body(A)
Page 2 OF 4
Step 1
Step 2
Your Ottoman is ready for use.
Caution :This Ottoman can only be used on a flat, level surface.
Position Ottoman Body(A) facedown on a clean, non-marring surface.
Install the Leg(B) into the bottom of the Ottoman Body(A) by placing a Plastic
Washer(①) onto the threaded stem of the Legs.
And then insert the threaded stem into the threaded mounting position at each Corner
of the Bottom of the Ottoman Body(A).
Tighten by turning the Legs clockwise.
Note: The use of Plastic Washer(①) are OPTIONAL and are especially useful to help
alleviate slight wobbles. Some Legs may need more than one Plastic Washer whilst
some Legs may not need any.
Position Ottoman right side up and test for stability on a Level Surface.
Add or remove Plastic Washer(①) where needed to achieve stability.
This Ottoman set has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Ottoman parts, the above picture is to help you put the
various Ottoman parts into perspective. Please read through the instructions to
familiarise yourself with the parts and steps before assembly.
Ottoman Body(A)
Plastic Washer(①)
Leg(B)
Page 3 OF 4
Page 4 OF 4
Loading...