ZOJE ZJ5820, ZJ5821 Operating Manual

7

15

16

18

5. Basic Operating Instruction

5 Basic Operating Instruction

5-1 Operation Panel

（Front Side）

4

（Right Side）

① Pattern Data Display Area ② Function Mode Button Area
③ Power Cable U④ Disk Port

19

5. Basic Operating Instruction

5-2 Basic Operation

① Turn on Power

After user turns on the power, the system will
display the contents at below in order at the Pattern
Data Display Area：

Welcome to using SC511 Buttonhole Machine
→SC511-00（01or 02）→Create Data→ Please Start
Switch.

Note：If figure A “EB012” is displayed on the
operation panel when user turns on the power supply,
please turn the wheel (1) in the directions shown in
figure B and make the print (2) face to the gap (3)
directly.

（A） （B）

② Step Pedal for Start

After user stepped the right pedal for start, the
feeding board will move to the position where the
cloth is located. In the operation panel, the readiness
status of the previous operation mode (it might be
Auto Mode, Manual Mode, Test Mode, Cycle Mod
Program Mode) will be displayed.

e or

Note：The “Readiness Status” is the status before
the next action when the system moves to a mode.

20

5. Basic Operating Instruction

5-3 Settting Methods of Patten Program

5-3-1 Interface for Inputting Sewing
Data

The data input interface is shown In
the right figure. For detailed functional
instructions, please refer to Table 1:
Button Instruction Table.

Table 1：Button Instruction Table：

No. Figure Functions Remarks

1 Display of Sewing Shape

Display the pattern number, patter
shape, length, stitch number, sewing
speed and so on.

2

Decrease Number of
Software & Parameter

3

Increase Number of
Software & Parameter

4

Increase Value & Parameter
Content

5

Decrease Value & Parameter
Content

6

ENTER（Confirmation）Key

Confirm the parameter and the pattern
data.

7

Unlock Panel：
Lock Panel：

8

Cloth-tightening
Permitted:

Cloth-tightening
Forbidden:

The default setting is the
Cloth-tightening Permitted. If user sets
it as Cloth-tightening Forbidden, this
parameter will return to default setting
when one pattern is finished.

21