Page 1
Vandal-proof Indoor Dome
User’s Guide
CM-P21223SV
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 2
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
SAFETY PRECAUTIONS
CAUTION
1. Do not dr op objects on the product or apply strong
shock to i t. Keep away from a location subject to
excess ive vibration or magnetic interfere nce.
2. Do not in stall in a location subject to high
temper ature (over 110 F), low temperature (below
0F), or hi gh humidity. Do ing so may cause fire or
electr ic shock.
3. If you wa nt to relocate the already installed
produc t, be sure to turn off the power and then
move or re install it.
4. Remov e the power plug from the outlet when then
there is a l ightning. Neglecting to do so may cause
fire or da mage to the product.
5. Keep ou t of direct sunlight and heat radiation
source s. It may cause fire.
6. Insta ll it in a place with good ventilation.
7. Avoid aiming the cam era directly towards
extrem ely bright objects such as sun, as this may
damage t he CCD image sensor.
8. Appara tus shall not be exposed to dripping or
splash ing and no objects filled with liquids, such as
vases, s hall be placed on the apparatus.
9. The Mains plug is used as a disconnect device and
shall st ay readily operable at any time.
CAUTIO N: TO RE DUC E THE RISK OF E LEC TRI C SHOCK, DO
NOT REMO VE RE AR COV ER. N O USE R SERV ICE ABL E PARTS
INSIDE . REF ER TO QU ALI FIE D SERV ICE P ERSONNE L.
CAUTI ON
RIS K OF ELEC TRIC
SHO CK DO NOT O PEN
Thi s symbo l indic ates hi gh voltage i s pre sent insi de. I t is
dan gerous to ma ke an y kind of con tac t wit h any in sid e par t
of th is prod uct.
Thi s symbo l alert s you tha t impor tant li terat ure con cerni ng
ope ratio n and mainte nan ce has been i ncl ude d with t his
pro duct.
WARNING
1. Be sure t o use only the standard adapter that is
specif ied in the specification sheet. Using a ny
other ad apter could cause fire, electrical sh ock, or
damage t o the product
2. Incor rectly connecting the power supply or
replac ing battery may cause explosion, fire ,
electr ic shock, or damage to the product.
3. Do not co nnect multiple cameras to a single
adapte r. Exceeding the capacity may cause
abnorm al heat generation or fire.
4. Secur ely plug the power cord into the power
recept acle. Insecure connection may cause f ire.
5. When in stalling the camera, fasten it secure ly and
firmly. A fallin g camera may cause personal injury
6. Do not pl ace conductive objects (e.g.screw drivers,
coins, m etal things, etc.) or containers fill ed with
water on t op of the camera. Doing so may cause
person al injury due to fire, electric shock, or f alling
object s.
7. Do not in stall the unit in humid, dusty, or sooty
locati ons. Doing so may cause fire or electric
shock.
8. If any un usual smells or smoke come from the unit,
stop usi ng the product. In such case, immediate ly
discon nect the power source and contact the
servic e center. Continued use in such a conditio n
may caus e fire or electric shock.
9. If this p roduct fails to operate normally, contact the
neares t service center. Never attempt to modif y
this pro duct in any way. (Z MODO is not liable for
proble ms caused by unauthorized modifications or
attemp ted repair.)
10. When c leaning, do not spray water directly onto
parts of t he product. Doing so may cause fire or
electr ic shock.
1
Page 3
PRODUCT OVERVIEW
Product Overview
Keep an eye on the people and places you care
about most with this vandal-proof color CCD
dome camera. Featuring imaging provided by
a 1/3” Sharp Color CCD, it delivers good video
quality, reliable operation, a long operating life,
and high value. With 12 built in IR LEDs, this
camera can capture video in night vision mode
up to 50’ away. This dome camera is designed for
indoor use, and can easily be mounted for the
perfect viewing angle. BNC and RCA connections
are used for video and power. Installation is easy
and hassle free, just plug and play.
Main Features
1/3" Sharp Color CCD Image Sensor
420 TV Lines, Horizontal
3.6mm Lens
Signal: NTSC
Vandal-proof: Yes
Iris: Auto
Night Vision Min. Light: 0 Lux (IR On)
IR Irradiation Distance: 50' (15m)
Operation Temperature: 0F ~ 110F
Mount: Ceiling or Wall
Video Connector: BNC
Power Connector: RCA 12V DC
1) CM-P21223SV Color IR Vandal Dome Camera
1) A Card
3) Screws
1) Allen Wrench
1) Package Box
Package includes
Please check your camera and accessories
included in the package. Those components are
as shown below:
WWW. ZMO
D
O
.CO
M
CC
D C
A
MERA
C
CD
CA
M
ERA
W
W
W.
Z
M
O
DO
.C
O
M
CCD
CAMERA
Camera Card
Screws Package Box
2
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 4
SCHEMATIC DIAGRAM
2
4
5
1
3
Dome Cover
Lens
LEDs
Tilt Fixi ng S cr ew
Main Body
3
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 5
CONNECTING CABLES
4
To connect cables
1. Connect the BNC cable to the video connector attached on your camera
2. Connect the BNC cable to the Video Input on a monitor, DVR or Video Balun.
3. Connect the power adapter to the RCA Power connector attached on your camera. When the
monitor is turned on, the camera image appears.
It is very important that you identify these ends before installing the cable so that you have the correct
ends at the correct location.
Note
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
BNC Cable
Monitor
RCA Cable
DVR
Vi deo Bal un
Page 6
HOW TO INSTALL
Before installation
Please read the following instructions before installing your camera:
You have to check whether the location (ceiling or wall) can bear five times the weight of your
camera.
Do not allow the cable to be caught in a pinched area, otherwise the electric line cover may be
damaged. This may cause cable breakdown or fire.
When installing your camera, don't allow anyone to walk or stand under your installation site,
and remove all valuable items. A dropped camera may cause injury to bystanders or harm to
valuable items.
Installation procedure
To install your camera
As showing in the picture, twist out the two screws using an allen wrench. Remove the Dome
Cover from the Main Body. This will reveal the camera’s Main Body.
1
step
5
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 7
HOW TO INSTALL
Fix the Main Body to the
mounting location using the 3
screws supplied in your package. As
shown in the picture, push the three
screws into the three holes on the Main
Body, then twist the screws into the
holes using the screwdriver.
2
step
Adjust the slope of the lens by
using the tilt fixing screw on the
two sides. Make sure that the front of the
clear plastic Dome Cover is facing the
camera’s monitoring area.
The round black Foam Insert should be
flush with the inside of the clear plastic
Dome Cover once the Dome Cover is
replaced onto the camera.
Note
3
step
Last, attach the Dome Cover to
the Main Body. Press the Dome
Cover onto the Main Body and then twist
in the two screws with the allen wrench.
The camera is now installed on the
mounting location.
4
step
6
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 8
CAMERA SPECIFICATION
Item Details
Color CCD IR Vandal Dome Camera
Yes
DC 12V
NTSC Sta ndard color system PAL Standard color system
(525 Lines, 60 Fields)
(625 Lines, 50 Fields)
Approx. 240mA
1/3 inch SHARP Color CCD
510(H) x 492(V), 250,920 pixels
NTSC Sta ndard PAL Standard
525 Lines 625 Lines
Internal Synchronization
420 TV Lines
0.0Lux (IR Lamps on)
12 LEDs
Visible up to 15m(50')
1.0Vp-p, 75ohms
Focal Le ngth
Zone
Limit of Viewing Angle
3.6 mm
Horizontal
Vertical
79°
69°
> 48dB
Auto Iris
Auto Gain Control
Auto Back Light Compensation
Auto Switching between Color and B&W by day and night change(D/N)
Silver
0F—110F
5"x5"x3.5"
1.1 lbs
Product type
Vandal-proof
Power input
Broadcast type
Power Consumption
Image device
Effective Pixels
Scanning mode
Synchronization mode
Horizontal resolution
Minimum illumination
IR Lamps
IR Distance
Signal output
Lens
S/N Ratio
Controls
Product color
Operation temperature
Size
Weight
Mounting
Wall or Ceiling
Specifications for NTSC & PAL Standard
7
1201-1205 ,Sangda Mansion, High Technology Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
Page 9
8
1201-1205 ,Sangda Mansion, High Techno logy Park,
ShenZhen, Guangdong, China
Fax: Tel: 0755-3363-1636 0755-3363-1639
This device complies with part 15of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
interference.
2) This device must accept any interference
received including interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 1 5 of FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio
communications. Operation of this equipment in
a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
Note
FCC Statement
(Waste Electr ic al & E le ct ro ni c
Equipment) (Applicable in the
European Union and other
European countries with
separate collection systems)
This marking shown on the product
or its literature, indicates that it shouldnot be
disposed with other household wastes at the end of
its working life. To prevent possible harm to the
environment or human health from uncontrolled
waste disposal, please separate this from other
types of wastes and recycle it responsibly to
promote the sustainable reuse of material
resources.
Household users should contact either the retailer
where they purchased this product, or their local
government office, for details of where and how they
can take this item for environmentally safe recycling.
Business users should contact their supplier and
check the terms and conditions of the purchase
contract. This product should not be mixed with
other commercial wastes for disposal.
Correct Disposal of This Product
SKU: CM-P 21223 SV
Loading...