Page 1
Island Installation
Parts Supplied:
Please unpack your range hood
when it is delivered and inspect
to ensure all parts are included.
1. Main Hood with all lights
and button banks preinstalled.
2. Adjustable Stainless
Chimney Cover
3. Flexible duct (not
pictured)
4. Packet of screws and
anchors
5.Island style mounting
bracket
6. Backdraft Damper
9
Page 2
Five Easy Steps to Installation
Step one: Locate the center
above the stove where the hood
is to be installed. Ensure that the
bracket will be secured to solid
wood backing. Install the duct
work in the center of the bracket.
Secure the upper end of the
bracket to the ceiling as shown in
fig.1.
fig.1
4
Step two: Attach back draft
damper to top of hood to prevent
outside air from entering. fig.2
Step three: Attach the lower
portion of the chimney to the
motor housing with the screws
provided. fig.3
fig.2
5
10
fig.3
Page 3
Step four: Attach the duct to the top
of the back draft damper. Place the
chimney sections over the lower
bracket section and on top of the
main unit. Pull the plug to the top of
the chimney sections. Attach lower
bracket to upper bracket at desired
height using screws provided. fig.4
Step 5: Make your electrical and
ducting connections. Use 6” rigid
duct wherever possible. Try and
minimize the use of elbows. More
elbows and longer runs create higher
static pressure. The hood comes
with a grounded three prong plug
4
fig.4
fig.5
that can either be direct wired or
plugged into a 20 amp. circuit. Next
slide the inner portion of the chimney
up around the upper bracket and
secure using the screws provided.
fig.5-6
6
fig.6
11
Loading...