E KR101E User Manual
1. E KR101E Profile
Profile:
Double frequency product E KR101E card reader (125KHz , introduction of
foreign core technology update and new production processes, completely independent intellectual property rights, small power consumption,
high sensitivity, far reading distance, high performance, low price, antiinterference, strong stability, mainly used in smart parking, access channel management, access control and so on industries, built-in receiving
antenna, standard operate frequency 125KHz , the use of contactless radio frequency ID cards with EM format cards.
Features:
¾ support EM cards
¾ A variety of communication interfaces, ID card has interfaces of
Wiegand 26, . Wiegand 26 can be set by the control system of
Wiegand reader, and the default setting is Wiegand G26. The Wiegand data format of card reader can also be set by the control system of Wiegand reader.
¾
1
E KR101E User Manual
¾ Small size, lightweight and compact appearance.
¾ Red light, green light, the buzzer with external control interfaces.
¾ Since using epoxy resins to seal completely, interferences of severe
environment can be reduced to the minimum.
Technical parameters
¾ Operate frequency of built-in receiving antenna: ID as standard
125KHz
¾ Read response speed: less than 0.2s
¾ Power supply specification: +DC12V
¾ Operate current: 100MA
¾ Appearance size: 77.5 *43.5* 16MM (L * W * H)
¾ Supported cards: ID cards
¾ Read distance: greater than 3CM (The distance is varied with the
card)
¾ Communication distance: Wiegand is greater than 50 meters
¾
Operate temperature: -10℃～+75℃ (low temperature and high
temperature may affect the product, if performance changed, it will
restore naturally after temperature recovery)
2
E KR101E User Manual
2. Appearance
Indicator
light
Connection
terminal
Sense
area
Front View Side View Back View
Indicator status: when power on, the buzzer will have a prompt sound
of ‘di’, indicating the complete initialization, at the same time the red
light will be lighted up; When brushing the card, the buzzer will have a
prompt sound of ‘di’, at the same time the red light is off, later the green
light will flash once; when in standby, the red light will be constant on.
Sense area: sense area of card.
Connection terminal definitions:
Type
Cable color and
definition
Function
Red（DC+12V） DC+12V
Power
connection
Black（GND） Ground cable
Green（WD0） Output Wiegand data 0 signal
White（WD1） Output Wiegand data 1 signal
Wiegand
Green LED Grey
Beeper Purple
connection
3
E KR101E Usrer Manual
3. Connection with access controller
E KR101E as a card reader, it can not work by itself, only can connect
with the access controller or access control device to provide a front-end
to identify cards. As below shown (when connection, please refer to
connection terminal definitions):
4
Loading...