ZISA CTP200, CTK200 User Manual

Keypad Transmitter and Coaster Pager

User Manual

1.Numeric Keypad Transmitter CTK200 Features

CTK200 is a very popular transmitter, its transmit power is bigger and has an
antenna can transmit the signal further.Moreover,it has a screen,you can see
the number you pressed.

1)Feature
Key life: million and above;

★

Operating temperature:0-55℃;

★

Power supply: DC 12V,1A, be equipped with adapter;

★

Transmitter Distance:800~1000 meters (open area);

★

Material: ABS plastic;

★

Screen : 74X 37mm,4 digits;

★

Frequency: 315mhz

★

Dimensions: 160X 115 X 80 mm;

★

2)Setting the mode of CTK200

When using transmitter CTK200 to work with Pager CTP200,the transmitter

should be Model 2 and long code.

Pressing and holding the key “2” until you switch CTK200 on the power.
If its screen shows: 2 L (it means mode 2,long code),the transmitter can be
used. But If the screen shows: “2 5”, (it means mode 2, short code). Unplug
the power, press and hold the key “+” until switching it on the power again, the
screen will show 2 L.

The transmitter just need be set at the first time.

2)Operation manual of Guest Pager CTP200

3. CTP200

Coaster

Pager

pager

Coaster pager is one of our most popular products.It is portable,user-friendly,

has novel design and widely used in many areas.

One keypad transmitter can maximally work with 99pcs pager CTP200.But

one pager CTP200 just can work with only one keypad transmitter.

1)Features

Tube size: 0.28 inch RED LED display, 4 digits;

★

Shell material: High quality polycarbonate;

★

Prompt mode: Flash, Bell, Vibration or any combination of them;

★

Prompt period: 15 seconds to 90 seconds, flexible changing;

★

Frequency: 315mhz

★

Dimension: 103×103×15.6 (mm);

★

Power: Built-in 3.7V lithium battery;

★

charging period: 8 hours;

★

Standby Time: 7days;

★

The function key “Time” “Mode” “Learn” “Stop” on the back of CTP200 could

be activated by a pinpoint.

Setting of Number Registration

※

Touch the “learn” key, and the screen will show “- - - -“, now press a number
(01~99),and press "ENT" on the keypad transmitter, when this number is
shown on the pager's screen, the registration is successfully done.The number
could be changed in the same way.