Page 1
Zippers High Flow Air Cleaner
List of Materials
(1) Gasket, carb to a/c backplate (1) Air lter element
(3) Air lter mounting stanchion (1) Air cleaner backplate
(2) Breather spacers (3) Torx head cap screws
This product is legal in California only for racing vehicles
which may never be used upon a highway.
Installation Instructions for
# 117-460
1. Remove existing air
cleaner cover, element with cover
mounting bracket and plastic
backing plate. Do not remove
the black head-to-head throttle
body support bracket.
Retain factory supplied cover with mounting
screw, cover mounting bracket, (2) each
breather bolts and breather hose assembly.
2. Apply a locking agent
such as Loctite 242 (blue) to the
original breather bolt threads,
place the screw through the
breather spacer and install the
(2) breather spacers, one on
each head, and tighten.
3. Apply a locking agent
such as Loctite 242 (blue) to the
threads of the (3) stanchions;
position the backing plate in
position over the throttle body
with supplied gasket and start
the stanchion threads into the
throttle body. Tighten all (3)
stanchions to 85-90 inch pounds
in a sequence.
4. Install original breather
hose assembly to breather bolt
nipples as shown.
5. Apply low strength
threadlocker such as blue Loctite®
to (3) Torx head screws provided
and install the lter element with
original cover mounting bracket
to stanchions. Apply threadlocker
to original cover mounting screw
and re-install factory cover.
Tips For Cleaning Your
High Flow Filter Element
Gently shake off and brush away excess
dirt. Spray on Cleaning Solution so that
the lter is fully saturated, and let soak for
10 minutes. Rinse lter from the clean side
to the dirty side until water comes through.
Use only low pressure from a tap or hose.
Allow lter to dry. A fan may be used to
speed process. DO NOT use heated
air blowers, compressed air, or open
ame.
Make one careful application of Filter
Oil to each lter pleat.
Allow oil to seep into lter for 20 min-
utes. Re-oil any areas that still appear
dry. Do not over oil.
Thank You for Purchasing a
Zipper’s Performance Product!
6655-A Amberton Drive, Elkridge, Maryland 21075 410-579-2828
Loading...