Page 1
ASSEMBLY INSTRUCTION
752-04 FAUX MARBLE TOP END TABLE
A
Table Top
B
Connector
C
Table Leg
D
JCBC Bolt
M8 x 40mm
1 pc
1 pc
3 pcs
6 pcs
Lock Washer
F
Flat Washer
G
Allen Key
M8
M8 x 16
M5
6 pcs
6 pcs
1 pc
This page lists all the contents included in the
box . Please ta ke the ti me to id entif y the
hardware as well as the individual components
to this product. As you unpack and prepare for
assembly, place the contents on a carpeted or
padded area to protect them from damage.
1
Page 2
Place the Table Top (A) upside down on a smooth carpeted surface. Place the Table Leg (C)
to the position, aligning the hole of the Table Leg (C) with the hole of metal connector on the
Table Top (A) as shown below. Then insert Flat Washer (F), Lock Washer (E) and JCBC Bolt
(D) with Allen Key (G). Do not fully tighten the bolts at this step.
2
Page 3
Attach Connector (B) with Table Leg (C) by using Flat Washer (F), Lock Washer (E) and JCBC
Bolt (D) with Allen Key (G). Fully tighten the bolts at this step.
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface
with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time.
Periodically check that all connections are tight.
3
Page 4
ASSEMBLY INSTRUCTION
752-30 FAUX MARBLE TOP COFFEE TABLE
A
Table Top
B
Connector
C
Table Leg
D
JCBC Bolt
M8 x 40mm
1 pc
1 pc
3 pcs
6 pcs
Lock Washer
F
Flat Washer
G
Allen Key
M8
M8 x 16
M5
6 pcs
6 pcs
1 pc
This page lists all the contents included in the
box . Please ta ke the ti me to id entif y the
hardware as well as the individual components
to this product. As you unpack and prepare for
assembly, place the contents on a carpeted or
padded area to protect them from damage.
1
Page 5
Place the Table Top (A) upside down on a smooth carpeted surface. Place the Table Leg (C)
to the position, aligning the hole of the Table Leg (C) with the hole of metal connector on the
Table Top (A) as shown below. Then insert Flat Washer (F), Lock Washer (E) and JCBC Bolt
(D) with Allen Key (G). Do not fully tighten the bolts at this step.
2
Page 6
Attach Connector (B) with Table Leg (C) by using Flat Washer (F), Lock Washer (E) and JCBC
Bolt (D) with Allen Key (G). Fully tighten the bolts at this step.
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface
with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time.
Periodically check that all connections are tight.
3
Loading...