Page 1
PRODUCT NAME：
55'' TV Stand with LED
ASSEMBLY
INSTRUCTION
01
Page 2
HELPFUL HINTS
BEFORE YOU START
Inspect product packaging to ensure the appearance is good.
Read the assembly instruction carefully and follow it step by step.
To avoid any scratching, putting a soft blanket on the floor
is suggested.
Identify, sort and count all the parts with tags.
Find out installation position according to the drawing and install
it in correct steps.
OTHER
People needed for assembly: 2
Estimated assembly time: 1-1.5hour
CAUTION
Be cautious when using a power drill or power screwdriver.
Please be aware to slow down and stop when screw is nearly tight.
Do Not use any harsh chemicals or abrasive cleaners for this item.
Push, pull or drag this item carefully.
DETAILS
15.75"
3.02"
23.62"
UNIT:INCH
55.12"
3.4"
02
Page 3
PARTS LIST
03
Page 4
ACCESSORIES LIST
Screw WE is not needed throughout installation. Please just keep it.
STEP 1
Notice:
※
For Part 4, no edge banding, and no
pilot hol e.
For Part 6, no edge banding, but with
pilot hol es.
※
Firstly, place a soft blanket on the floor to well protect the
boards, then start installation.
STEP 2
※Partial ly tighten t he screws.
04
Page 5
STEP 3
M6x12
T5x35
S
STEP 4
2
4
STEP 5
※Two persons are needed to keep
the board in balance when screwing.
※Partially tighten the screws.
※Tilt the mesh shelf and carefully
put it into the TV stand.
Two persons are needed to keep it
in horizontal position for Step 6.
05
Page 6
STEP 6
※Two persons are needed to keep
the board in balance when screwing.
※Partially tighten Screw A and fully tighten
other screws in this step.
M6x12
※ Make sure Screw C go through
the SMALLER hole of WC when
installing WC.
6
STEP 7
※ Partially tighten all Screw C.
※ Make sure Part 10 and 11 are well-aligned,
then tighten up all Screw A.
※ Fully tighten all screws.
06
Page 7
STEP 8
※ Gently turn over the TV stand with
top panel downwards.
Fully tighten all screws and
install “F”.
STEP 9
07
Page 8
STEP 10
※Please fasten this item to wall for protection and safety.
1. Drill 2 ho les ( d ia 5/ 1 6") in t he wall and in sert WB into h oles.
Hole position: appr oximatel y 2" BELOW the c orrespon ding posit ions of WC ins talled on th e TV stand.
※You may nee d to use rubbe r mallet for t apping WB.
2. Use WA to a ttach WB with WC.
※WA must go th rough the sm aller hole o f WC and make sure the tab with larger hole is UPWARD.
3. Use WD to co nnect the co rrespond ing WCs and ti ghten them a s desired be fore locki ng in place.
08
Loading...