
CHAIR/SOFA
Thank you for purchasing this chair/sofa!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair/sofa, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Hardware:
Component:
A
B
C
D
Bolt M6x30mm x 12
Spring Washer M6 x 12
Flat Washer M6 x 12
Allen Wrench x 1
2
1
Chair/Sofa Body x1
3
2
Front Leg x2
Page 1 of 3
2
1
3
3
Back Leg x2

CHAIR/SOFA
STEP 1:
Please put the Chair/Sofa Body (1) upside down on a carpeted or padded area by two adults.
Open the Zipper on the bottom of Chair/Sofa Body (1) as shown, to make the corners fully visible .
Take out 4 pieces of Leg (2&3) and Hardware Package from the inside of Chair/Sofa Body(1).
Zipper on the bottom of chair/sofa body
4pcs Leg
+
Hardware Package
1
D
A
STEP 2:
Position one of Front Legs (2) at the corresponding corner as shown.
Insert 3 pieces of Bolt (A) with 3 pieces of Spring Washer (B), Flat Washer (C) into the pre-drilled holes on the bottom
Chair/Sofa Body (1) through the pre-drill holes on Front Leg (2) as shown.
Repeat the same steps for the remaining Front Leg (2) and Back Legs (3).
Use Allen Wrench (D) to tighten all the Bolts (A) clockwise until secure.
Close the zipper on bottom of Chair/Sofa Body (1).
A
A
B
B
C
C
C
B
A
A
C
B
C
A
B
A
B
C
2
B
C
C
B
A
1
3 3
A
B
C
C
A
B
2
B
C
A
A
B
C
Ax12
Bx12
Cx12
Dx1
Page 2 of 3
Hardware & Tool required

CHAIR/SOFA
STEP 3:
Carefully turn over the assembled chair/sofa.
Assembly is completed. Your chair/sofa is ready to be enjoyed now!
Page 3 of 3