Zip 93441 Installation Guide

File Ref : C:\Zip_PDM\Engineering\Projects\Project 10015\2. Design\Fonts\93441
Sheet1 (Default)
50
100
176
150
200
250
300
350
THIRD ANGLE
PROJECTION
Dimensions in
millimetres
Drawing to
BS8888:2004
Screw threads to
BS 8498:2008
Zip Industries Pty Ltd
67 Allingham Street Condell Park Sydney NSW 2200 Australia
Web : www.zipindustries.com
Email : sales@zipindustries.com
400
155 P.C.D.
250
200
150
30°
A
250
200
A
30°
150
100
TOP VIEW
135
3
100
M6 Threaded
This drawing is CONFIDENTIAL and is supplied on the express condition that it shall not be LOANED, COPIED or DISCLOSED to
50
Rod in 3 positions
as shown
SECTION A-A
SCALE 1 : 1.5
50
100
150
ERROR!:Approval Number
ERROR!:Approval Expiry Date
200
any other third party or used for any purpose without the written consent of Zip Industries Pty Ltd. If this document is printed in hardcopy form, it is for INFORMATION ONLY and therefore not subject to updating controls. For the current revision ALWAYS refer to the NATIVE electronic form as stated in the top left-hand corner of this sheet. © copyright Zip Industries Pty Ltd, 10/04/2015
Manufacturing Instructions
Make or Buy :
Manufacturing Route :
Raw material :
Remove all sharp edges. This drawing ONLY details information which cannot be ascertained from the 3D geometry of the part(s) attached. Model & dimensions are AFTER all finishing operations
Comments :
This Kit is suitable for G4 HydroTap Classic Tap, HydroTap Elite, HydroTap Arc & Cube with corresponding distances from the centre of the Taps to the centre of the Font.
Potable? :
Buy
See Components
See Components
Recyclable? :
Handed? :
NoNo
No
Approved by :
Checked by :
Updated by :
Material :
See Components
Finish :
See Components
Volume
Mass
Unapproved on 1/01/2001
edgarg on 10/04/2015
edgarg on 10/04/2015 12:02:39 PM
:
(cm3)
:
(g)
133.4
690.4
Area
Density
:
(cm2)
ERROR!:Density
(g/cm3)
Zip Industries
Description :
Project :
Model :
Drawing :
Derived from :
1485.7
:
Scale :
Kit Stand Alone Font CH Bright Chrome
HydroTap G4®
93441
93441
ERROR!:Derived From
1:5
Sheet : 1 of
1
Configuration :
Created by & on
Colour :
ERROR!:Colour
Production
Status :
_Drawing
Property
Default
EdgarG on 28/01/2010
Created by & on
EdgarG
on 10/04/2015
Config
Property
Rev
A
Size
A3
Custom
Property
R
Loading...