Zimi LYYX01ZM User Manual

User Guide
SoundCannon™ Turret-I
Portable Bluetooth Speaker
Model: B208
Getting to know your Bluetooth speaker
Control Dial: Power Button & Volume Control
Remove the protective silicone O-ring before use
Power on/off
(Press anywhere on
the control dial)
WARNING: Always charge your speaker with a quality Micro-USB charge cable. A wet or dirty Micro-USB connector may create excess heat during charging, which may cause melting, re, or personal injury.
Front Back
LED Indicator
Turn
clockwise to
up the
volume
Volume Control
Micro-USB
Charging Port
Turn counter­clockwise to
lower the
volume
Power on/off
Press and hold the control dial for 2 seconds to power on/off. Release when you hear a sound. To save power, the speaker will turn off automatically after 10 minutes without Bluetooth connection or user interaction.
Pair with a device for the rst time
Turn on Bluetooth on your device and select ZMI SoundCannon Speaker. After successfully paired, the speaker will sound to conrm that it is ready to play, and the LED indicator will then ash a blue light at a steady, slow pace.
Pair with a different device
Turn on the speaker and double-press the control dial. When you hear a sound and see the blue light start ashing rapidly, follow the instructions
1
in the preceding paragraph to pair with a new device.
2 3 4
Features
Play audio
While the speaker is on and connected, you can play any audio content from your source device.
Speakerphone
The speaker has a built-in mic that allows you to take incoming calls. When you receive a call on your audio source device, the speaker will prompt you of the incoming call. Press the control to answer the call and press it again to end the call.
Adjust volume
You can adjust volume while playing audio or taking a call. You can adjust the volume from your source device or by turning the control dial on the speaker.
Charging the battery
Connect the speaker to a USB wall charger or portable charger using a good quality Micro-USB charge cable. The LED indicator will ash a red light while charging is in progress. The LED indicator will turn solid blue when charging is complete.
WARNING: Always use a qualied 5V USB wall charger or portable charger. Unqualied chargers may result in damage to the speaker or even risk of re.
Control dial actions
Action
Press the control dial when the speaker is on
Double-press the control dial when the speaker is on
Press and hold the control dial for 2 seconds
Turn the control dial clockwise
Turn the control dial counterclockwise
LED indicator states
Speaker status
Waiting to connect
Connecting
Incoming call
Ongoing call
Charging in progress
Charging complete
Low battery
LED light
Flashing blue rapidly
Flashing blue slowly
Flashing white rapidly
Flashing white slowly
Steady red
Steady blue
Flashing red
Function
1. Pause/Play
2. Answer/End call
1. Disconnect from Bluetooth, enter pairing mode
2. Connect to the previously paired device if disconnected
3. Reject incoming call  
1. Turn on
2. Turn off
Volume up
Volume down
Be in charge, anytime, anywhere
Specications
Product name
Model
Bluetooth version
Operating range
Maximum playback time
Maximum output
Speaker impedance
Battery capacity
USB input
Dimensions
Operating temperature  
WARNING: This product uses radio signal to connect to Bluetooth devices. The connection may not be stable or reliable on some occasions. Do not rely solely on this product’s performance in case of emergency.
SoundCannon Turret-I Portable Bluetooth Speaker
B208
4.1
10 m
7 hours when fully charged
5W
1,200 mAh 3.7V
5V 1A
2.36 × 2.36 × 3.67 in
32° to 104°F (0° to 40°C)
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiates radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced ratio/TV technician for help.
18-Month Limited Warranty
The product has an 18-month limited warranty, unless the warranty is voided by one or more of the following:
Unauthorized repair, incorrect use, drop, negligence, abuse, liquid damage, accident, alteration, improper use with non-ZMI-branded accessories, or removing or altering product labeling
Warranty expiration
Force Majeure
Web: zmiusa.com/support Email: support@zmiusa.com Phone: +1 (844) 828-2302
ZMI USA Corporation, 120 San Lucar Ct, Sunnyvale, CA 94086-5213
For FAQs and more information, please visit:
zmiusa.com/support
@zmiusa
@zmiusa
@zmiusacorp
RF Warning Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
5 6 7 8
V1.0
印刷颜色: PANTONE COOL GRAY 9C
K100
Teal R52,G172,B199
建立
凌浩
材质:105克金东太空梭无光铜,上水性哑油
B208 亚马逊版
2017/09/13
说明书
Loading...