ZIGBEE RC-02 User Manual

Page 1
Operating and Installation Instructions for RC-02
1
CONFIDENTIAL : RC-02-0113
RC-02
Smart Home ZigBee Wireless Remote Control
Page 2
2
Operating and Installation Instructions for RC-02
CONFIDENTIAL : RC-02-0113
Smart Home system by using mobile devices to provide home security and
environmental care. After installing the service controller and all the necessary sensors, users can access control, monitoring home environment, or send instant messages via controller after receiving information from mobile device.
Wireless Remote Controller
RC-01 is a four-button remote control using ZigBee signal to set up service controller (host) in order to control end device.
Dual LED
One single button to active alarm
Combination keys function available
Low battery indication available
Product Specication
Wireless Standard Network IEEE802.15.4 ZigBee PRO, 2.4GHz
Output Power 1dBm (max.)
Receiving Sensitivity -97.5dBm (min.)
Power Supply 3V CR2032 Li-ion Battery
Battery Life
Normally over One year (Depending on the way of usage)
Transmission (Operation) Range 50 meters (free space)
Operating Temperature 20°C ~ 40°C
Operating Humidity 0%~95% (Non-condensing)
Product Feature
Page 3
Operating and Installation Instructions for RC-02
3
CONFIDENTIAL : RC-02-0113
Button Function
Night Mode
Panic Button
Arm
Disarm
LED lndicator
Arm Button
When you are out of home, please press this button to set up the alarm, and all detector at home are at alarm status.
Disarm Button
When you are at home, please press this button to dis-alarm.
Night Mode Button
Press this button will start the partial detectors in accordance with the system settings, in the same time, the sensor will be in a state of alert.
Panic Button Button
Press this button to connect to the emergency contactor, for example, buzzer, siren
or contact to the emergency contactor. And this would need to be set up at very rst
place.
Product Specication - Continued
Dimension 55 (L) x 32 (W) x 8.5 (H) mm
Weight 20 g
Page 4
4
Operating and Installation Instructions for RC-02
CONFIDENTIAL : RC-02-0113
Reset the Remote Control
When you rst time use the remote control, please reset it and please follow the steps
as below
Insert the CR2032 battery.
**While doing this, please be very careful of the material on the PCB, strong push might damage or break the components on PCB.
After insert the battery, the Red LED will ash about 0.5 second.
Please press Arm button 3 times, then Orange LED will ash 3 times.
Press Panic button 3 times within 3 seconds, then the Orange LED ash 3 times,
after this, Red LED will ash once and turn off.
Join Controller
Press either Arm or Night mode button, then LED ash fast.
Press any key, Green LED ash 3 times means join successfully.
Once it is joined successfully, the service control panel will also shows "ACE join OK".
The remote control is not water-proved.
Do not use or store in dusty or dirty areas. This will damage its electronic
components.
Please avoid hot and cold areas. High and low temperatures would shorten
the life of electronic devices and damage battery.
Do not use harsh chemicals, cleaning solvents, or strong detergents to clean it.
Do not drop, knock, or shake the device. Rude handling can break internal
circuit boards and ne mechanics.
Attention
FAQ
Q:Remote control not working A
Make sure if it is successfully joined the service control panel.
Make sure if the battery is install properly.
Press any key to make sure if the LED ash once.
Make sure the control is within the operation range.
Page 5
Operating and Installation Instructions for RC-02
5
CONFIDENTIAL : RC-02-0113
Contact Us
Nietzsche Enterprise Co., Ltd. (NHR), est. 1978, is an
ISO9001 certified manufacturer, has been engaged in
wireless communication and power solutions for over 36
years and continues to focus on meeting current and future
market needs in Wireless Sensing Network. NHR's design
center and factory are in Taipei, Taiwan, with a commitment
to solving constraints from wires and cables through
delivering intuitive, convenient, reliable, and rapid return
on investment wireless solutions to customers. Products
and solutions include agriculture, logistics/transportation,
energy & water management, security & maintenance,
industrial, asset management, and aquatic. For more
information, visit our website at
www.nhr.com.tw
SentrolCloud
is a sensor cloud platform for Automated
Control and Instant Out-limit Alert. Using a world-leading
cloud storage service provider to ensure the data is secure
and always accessible from anywhere via any web-enabled
computer, tablet, or smart phone, SentrolCloud interface
puts intuitive monitoring and control at your fingertips
allowing for 1-second rapid decision-making and more in-
depth trend analysis. For more information, visit our cloud
platform at
www.sentrolcloud.com
www.shop-wifi.com/wireless-sensors
e-mail: zigbeenhr@shop-wifi.com
Loading...