Power supply
DC 1.5V (AA 1.5V LR6 Battery x 1 pc)
Static current
<35uA
Alarm current
<40mA
Transmitting distance
< 80m (in open
area)
Radio frequency
315MHz/433.92MHz (±75KHz)
Housing material
ABS plastic
Operating temperature
0°C~+55°C
Relative humidity
< 80% (non-condensing)
Transmitter dimensions (LxWxH)
71x34 x 17.5mm
51 x 12 x 13.5mm
Magnet dimensions (LxWxH)
Zicom Electronic Security Systems Ltd.|
Address: 501, 5th Floor, Silver Metropolis, Goregoan (E), Mumbai–400 063, India.
Website: www.zicom.com | Toll Free : 1-800-270-4567
Wireless Door/Window
Contact
Z.HA.HA.MC.ATOUCH.SENSOR
User Manual
Introduction
The Z.HA.HA.MC.ATOUCH.SENSOR is a Door/Window
Contact that can be installed on doors, windows, and any other
objects that can be open and close. The sensor transmits signals
to the control panel when a magnet mounted near the sensor is
moved away. It will also transmit alert signal to the control panel
in case of low battery The tamper protection ensures that
sabotage attempts to move the contact will result in an alarm
activation.
Specifications
PCB Layout
LED Indication
LED flashes once: Door/window is opened and transmitter
sends signal to the control panel.
Flash once per 3 seconds: Low power indication, please change
battery as soon as possible. (User will get alert SMS about the
low battery if the door contact is connected to the GSM alarm
system.)
Installation & Notice
Open the case and remove the battery activation strip.
Mount the sensor on the door frame and the magnet on the
door.
Make sure the magnet is on the right side of the transmitter
Place the transmitter in the desired location, mount the
magnet no more than 1cm away from the transmitter and
secure the transmitter and magnet with double-sided tapes or
screws.
Avoid mounting sensors in areas with a large quantity of metal
or electrical wiring, such as a furnace or utility room.
Product Overview
NOTE: When tamper switch is triggered, it will send out alarm signa
immediately.
Zone setup
Loading...