Applicant
Manufacturer
Trade Mark
EUT
M/N
FCC Statement:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Zhuhai Rocateq Technology Company Ltd
:
D,3rd Floor 1# Factory 8,Chuang Xin Liu Road,Xiangzhou
District,Zhuhai,Guangdong,519085,P.R.China
Zhuhai Rocateq Technology Company Ltd
:
D,3rd Floor 1# Factory 8,Chuang Xin Liu Road,Xiangzhou
District,Zhuhai,Guangdong,519085,P.R.China
: Rocateq
: Master Remote Unit
: MRU
MRU USER MANUAL
Caution: Any changes or modif cations to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
1
Description
The MRU COP is used for locking, unlocking and mute for series products
of shopping caster, including STD, OCS, STD-COP, OCS-COP etc. Frequency
for locking & unlocking is 8.13KHz. Frequency for mute is 318.06MHz(Refer
to image 1 for appearance & dimension)
图 1
2.
Technical information
2.1 Requirement on appearance
No scratch on visible surface; Consistent color on housing; With right
hole positions for easy assembly; With right position for LED lights; No
function defect.
2.2 Requirement on assembly :No loose and noise for components after
assembly。
2.3 Main outer dimensions shall meet requirements of image 1
2.4 Parameters
No. Item Specification Remark
Normal
temperature
1 Working voltage 9V ±10% ±10%
2 SleepMode Current <20 uA ±10% ±10%
3 Locking Current <50mA ±10% ±10%
4 Unlocking Current <50mA ±10% ±10%
Tolerance for -20~
45℃
Tolerance for normal
temperature
5 Mute Current <50mA ±10% ±10%
2