Zhuhai RaySharp Technology RS SNW, RS SNW User Manual

W

I

F

I

K

I

T

U

S

E

R

M

A

N

U

A

L

L

A
U
N
A

M
R

E
S

U
T

I
K

I
F

I

System Connection:

POE

Remark: If NVR with POE function, then the WIFI box no needs power supply separately .

W

DC/12V power

wifi pair key PAIRING

/12V power
C
D

ANT Antenna

WAN port

LAN por t

Wifi signal indiator

WIFI reciver box and wifi camera

CH status indiator

Power indiator

Wifi cha n switc h CH-SEL

WIFI pair key PAIRING

Pairing operation:

2. Every press to pairing key on the wifi receiver box, the indicator of camera will slow flicker 5Seconds. During this period, to long press PAIRING and when the

1. Check the indicator of PWR is on, and then press PAIRING key, to do pairing with wifi camera.

indicator of camera to be fast flicker then loosen the key. After into the fast flicker, press the PAIRING key of camera, then system will go to auto pairing recognition.

If during the slow flicker 5s don't do pairing operation, all camera indicator will fast flicker 5s and then withdraw from pairing operation.

Remark: when the wifi recevier box and wifi camera are out of factory, we already make pairing job, so user no need to do pairing operation, but some conditions need

to do the pairing again, please do as above instruction.

4. When 4 camera all pairing, all the indicator of camera will be in regular flicker, then means.The cameras in the normal communication.Then, user can add the camera

3. After pairing successful, the indicator of pair channel camera stop fast flicker, and then all Camera indicator will keep fast flicker for 5 seconds. And the camera

to the menu to NVR device.

with successful pairing. Will be with regular flicker and means complete the pairing.

Wifi channel selection:

1. Default wifi channel level is L. When there are other wifi interfere, then you can adjust it to other.

2. every press button CH-SEL，the indicator of CH(H-M-L) will slow flicker 5 seconds. During this time, long press CH-SEL to the indicator of CH(H-M-L) to be fast flicker

and then loose, the selected CH(H-M-L) will be on light, then mean you switch the selected signal channel.