Oplink Communications
SRN1300 User Guide
I. Product Introduction
SRN1300 is a 433MHz wireless siren; if it receives an activating signal from the
system, it will sound loudly and indicator light will flash. Siren can be stopped
manually by remote control.
System Structure
1 / 3
Oplink Communications
II. Installation
(1) Determine the location of the Indoor Siren, which should be placed:
• Indoors and way from direct sunlight.
• Away from extreme temperature sources and large metal objects.
• Within a few feet of an electrical socket, so the AC adapter can be
easily used.
(2) Installation:
• Hang the siren on to the wall by keyhole, using the wall plugs and
screws provided.
• Power on Siren. The indicator light will flash every five seconds when
the siren is powered on.
III. User Instruction & Workflow
(1) The siren works in stand-by mode normally.
(2) If it receives an activating signal from the system, it will sound loudly and
indicator light will flash.
(3) Siren can be stopped manually by remote control.
2 / 3
Oplink Communications
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
3 / 3
Loading...