Zhuhai FTZ Oplink Communications PNB02 User Manual

Federal Communications Commission Statement

DWM1301

V0

1000823

6B1H-21003

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try and correct the interferene by one of
the following measures:
Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiver,
Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undersired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Oplink Guarantees that every wireless door/window sensor is free from physical defects in
material and workmanship under normal usage for one year from the date of purchase. If the
product proves defective during this one-year warranty period, Oplink will replace it free of
charge. Oplink does not issue any refunds. This warranty is extended to the original end user
purchase only and is not transferable. This warranty does not apply to : (1) damage to units
caused by accident, dropping or abuse in handling, or any negligent usage; (2) units which
have been repaired, taken apart, or modified by an unauthorized personnel; (3) units not used
in accordance with instruction; (4) damages exceeding the cost of the product; (5) transit
damage, initial installation costs, removal cost, or reinstallation cost.
For information on addional devices, plesae visit us at www.oplink.com

Installation & Operation Manual

PNB1301

Transmitter
Panic Button

-3-

Specification:

Package Content:

Protocol: 433.92Mhz
Operating Range: Up to 200 feet line of sight
Operating Temp.: -15°C~ 60°C (5°F ~140°F)
Battery: Panasonic CR2032 * 1PC

1pc
1pc
1pc

PNB1301 Transmitter
CR2032 Lithium Battery
Installation & Operation manual

Introduction

Thanks for choosing the Oplink wireless transmitter of the home security device.
This transmitter when door arm or disarm is opened and closed.

Product Description and Specification

Installation

1. Before insert the battery, put home security control into learning mode. Once put CR2032
battery into the battery compartment and push the button then LED will light 1 time, and
PNB1301 Transmitter will automotive included into system.

Operation

1. Opening the Transmitter push button, the Transmitter will send signal to the controller, and

the LED will light 1 time.

2. Normal operation, the LED will not light.

3. If Transmitter is in low battery status, it will report a message to controller, and LED will

flash slow. Please change the battery.

-2-