Zhuhai FTZ Oplink Communications OPU03 User Manual

FEDERAL COMMUNICATIONS COMMISSION INT ER FER EN C E STATEMENT

T

his equipment has been tested and found to comply with the limit s for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment of f and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

C

AUTION:

Any changes or modif ic atio ns not expr ess l y approved by the p arty responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.

FCC RF Radiation Exposure Statement:

1.

This Transmitter must not be co-located or operating in conjunc
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

2.

This equipment should be installed and operated with a minimum distance of 20 centimeters between
the radiator and your body.

tion with any other antenna or transmitter,except in accordance to FCC multi-transmitter product procedures.