Zhongshan K mate General Electronics BTR017 Users Manual

BTR017N

Content

Bluetooth stereo receiver

User’s manual

 Before use…………………………………………………...…1

1. About BTR017N………………………………………...…….1

2. System requirements………………………………...…………1

3. Overview of BTR017N…………….………………….. .……...1

 Getting started…………………….……………………………2

1. Charging the receiver………………..………………………....2

2. Reeling the cable ....................…..…………………………...2

3. Turning on/off the receiver......................... ... ... ...... ...... ..... ....... ...3

4. Pairing with Bluetooth dev ices.......................... ........................ .4

1)How to enter pairing mode …………..………………….…4

2)Pairing receiver with Bluetooth cell phone..............................4

3)Pairing receiver with a Bluetooth cell phone via NFC........ .....5

4)Pairing receiver with Bluetooth transmitter.............................5

5. Playing music …………..…………………………………….6

6. LED indicator…………..……………………………………...6

 Care and maintenance………….……………… ………………7
 FAQs…………………………………..……………………….7
 Specifications……………………...…………………………...8

Welcome to use this Bluetooth stereo receiver BTR017N. Please read this

N

r

user’s manual carefully before use.

 Before use

1. About BTR017N

BTR017N is a stereo Bluetooth receiver. A common audio device also can
receive Bluetooth audio by using it.

2. System requirements

1)Audio device with 3.5mm audio input jack, such as speakers, radios etc .

2)Bluetooth transmitting device supporting A2DP profile, such as Bluetooth
mobile phones, Bluetooth transmitter etc.

3. Overview of BTR017N

1 Micro USB charging jack 4
2 LED indicato
3 MFB button 6 3.5mm audio input jack

5 The cable slot

1

FC induction zone

 Getting started

1. Charging the receiver

BTR017N comes with a built-in rechargeable battery, prior to using it, it is
recommended to charge the battery fully for the first time. When the
receiver emits a string of warning tones every 1 minute and the red LED
flashes. It means batt ery low. Please recharge the battery fully.

1)Plug the USB charging cable into the charging jack of PC or charger.

2) Plug the end of USB charging cable into charging port of receiver.
RED light on→Charging

RED light off→Finished charging

3) It will take about 2 hours to finish charging.

Warning:

The battery is recyclable.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat place, such as s unshine, fire or the like.

2 Reeling the cable

1) Please reel the audio line into the cable slot if you don’t use the product.
It is convenient to carry and store. Please operate it as shown below .

2