Zhongshan K mate General Electronics BTE018 Users Manual

BTE018

Bluetooth mono headset

User’s manual



Brief introduction

1. Bluetooth wireless communication technology…...........................1

2. About BTE018………………………………………………..…...1



Before use………………………………………………..1

1. Overview………………………………… ….....................…….…1

2. Charging the headset……………………………………...….....…2



Getting started……………………………………......…2

1. Power on/off………..………………………………..................….2

2. Pairing with a Bluetooth mobile phone………………..…..………3

3. Replacing ear cap…………………………………….…..….…….3

4. Making a call with the headset………………….............................4

5. Re-connecting with a Bluetooth device………..………….....….....5

6. LED indicator……………………………………………….….….5

7. Indication tone……………………………………………….….…6



Care and maintenance……………………………..……6



FAQs………. …………………………………………….7



Specifications…………………….….…………………...8

…………………………………………..…1

Welcome to use this Bluetooth mono headset, BTE018. Please read this
user’s manual carefully before use.



Brief introduction

1.

Bluetooth wireless communication technology

Bluetooth is a standard of close range radio-communication technology that
was drawn up by Ericsson, IBM, Intel, Nokia and Toshiba. With Bluetooth
technology, we can achieve the highest transmission rate among mobile
phones, computers, printers, PDAs and other devices. The max transmission
range of class II is 10 meters while the max transmission range of class I can
reach up to 100 meters.

2. About BTE018

BTE018 is a Bluetooth mono headset. It has the following features:



Answer a call, end a call and reject a call



Redial last number



Voice dial (This function needs to be supported by your mobile phone)



Call transfer between BTE018 and your mobile phone



Microphone mute

 Before use

1. Overview

Multi-function button (MFB): Power on/power off/answer a

1

call/end a call/reject a call/cancel calling/microphone mute/call
transfer/redial last number/voice dial

2 Built-in microphone
3 Ear cap
4 Loudspeaker
5 Charging jack
6 LED indicator

1

2. Charging the headset

The headset comes with a built-in rechargeable battery, prior to using it, it is
recommended to charge the battery fully for the first time.

Connect the charger to a computer USB port or a standard power outlet and
the charger plug to the charging jack of the headset. The red LED is on
while charging. It takes about 1.5 hours to charge the battery fully. When
charging is completed, the red LED is off.

When the headset is on and the battery becomes low, the LED flashes red
and the headset emits a string of indication tones every 15 seconds. Please
recharge the battery fully as described above.

Warning:

1) The battery is recycled.

2) Batteries (battery pack or batteries installed) shall not be exposed to

excessive heat place, such as sunshine, fire or the like.

 Getting started

1. Power on/off

Function Operation LED indicator

Power on

Power off

Entering
pairing
mode

Remark: In order to save power, the headset will turn off automatically if
no devices can be connected after 10 minutes.

Press and hold MFB button
for 3～5 seconds
Press and hold MFB button
for 3～5 seconds
Make sure BTE018 is off,
then press and hold MFB
button for 6～7 seconds

2

Blue LED is on for 1
second
Red LED is on for 1
second

LED flashes red and
blue alternately