Zhongshan Grand Enterprise GRAND User Manual
1
Super Switch Indoor
Wireless Remote Control
Wall Outlets
Red LED Indicator
Visor Clip
1 2 3
The Remote Control for Living Room, Kitchen & Bedroom Lights, Lamps, Fans and More
Item/Art. 770742 Model #: SSW2-3-3322
Set of (3) Indoor Outlets and (2) 3- Button Remote Controls
Package Includes:
(3) Wireless Wall Outlet Receivers (Receiver Units)
(2) 3-Button Hand-Held Remote Controls (Sender Units)
(2) Type 23A 12V batteries
Features:
The Super Switch operates on radio frequency and is not dependent on line of sight and will perform through walls, doors and
floors up to 60 feet away. No rewiring is required.
Hand Held Remote Control:
Red Transmit LED Indicator on Hand-Held Remotes lights up when buttons are pressed to confirm ON/OFF send command.
Button on Hand-Held Remote Control corresponds to Wall Receiver Units (1, 2, 3).
Clip on back of Hand-Held Remote Control is ideal to clip to car sun visor. Never enter a dark home again. Practical and
inexpensive peace of mind.
2
Wall Outlet Receivers:
1. Remove Safety Screw with # 3 Phillips Screw Driver.
2. Slide Battery Cover Out and Off.
3. Remove Protective Tape.
4. Reinstall Battery Cover by sliding back into place
5. Reinstall Safety Screw. Do not over tighten.
Red LED Indicator
Indicates Power ON
Manual ON/OFF
Press to turn Power
ON, Press to turn
Power OFF
Grounding Prong -
DO NOT REMOVE
NOTE: Wall Outlet Receivers feature 3-prong grounding plugs and are intended for use ONLY in 3-prong INDOOR
household AC outlets. DO NOT remove the round grounding prong. If your household AC outlets do not accept 3-prong
plugs then consult a qualified electrician to have your household AC outlets upgraded.
Red LED Indicators on wall Receiver Units indicate POWER SWITCHED ON at Wall Receiver Unit. Manual POWER ON/OFF
Override button on wall Receiver Units allows user to manually turn Wall Receiver Units ON or OFF in the event the Hand-Held
Remote cannot be located or if the battery in the Hand-Held Remote fails.
Operation:
Remove Protective Tape From Battery Chamber.
Remove battery cover on Hand-Held Remote Control unit and remove protective tape. To do this: 1) Remove the battery
compartment safety screw with a # 3 Phillips screwdriver. 2) Slide the battery compartment cover off. 3) Remove protective tape.
4) Replace battery compartment cover by sliding into place. 5) Reinstall the safety screw.
Loading...