ZHIXUAN ZXXS215-L01 Specification

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

A

U OPTRONICS CORPORATION

ZXXS215-L01

( V ) Preliminary Specification ( ) Final Specification

Module 21.5” Color TFT-LCD

Model Name ZXXS215-L01

Customer D

pproved by

A

ate

Note: This Specification is subject to change

without notice.

pproved by Date

A

Howard Lee

ared by

Prep

Eugene Hsu 2012/08/01

AU Optr

onics Corporation

ent version 0.3 1

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

ZXXS215-L01

Content

1 HANDLING PRECAUTIONS...................................................................................................... 5

2 GENERAL DESCRIPTION......................................................................................................... 6

2.1 Display Characteristics ........................................................................................................................ 6

2

2.

3 FUNCTIONAL BLOCK DIAGRAM .......................................................................................... 11

4 ABSOLUTE MAXIMUM RATINGS .......................................................................................... 12

4.

1

2

4.

3

5 ELECTRICAL CHARACTERISTICS........................................................................................ 14

tical Characteristics......................................................................................................................... 7

Op

T

FT LCD Module............................................................................................................................... 12

acklight Unit .................................................................................................................................... 12

B

A

bsolute Ratings of Environment....................................................................................................... 12

5.1 TFT LCD Module............................................................................................................................... 14

5.1.1

5.1.2

2

5.

B

6 SIGN

6.

P

1

6.2 Input Data Format Definition.............................................................................................................. 18

6.

S

3

6.4 Timing Diagram ................................................................................................................................. 22

5

6.

P

7 CONNECTOR A

7.

7.1.1

7.

7.2.1

7.2.2

T

1

LE

2

wer Specification ........................................................................................................................................14

Po

Sig

nal Electrical Characteristics .....................................................................................................................15

acklight Unit .................................................................................................................................... 17

AL CHARACTERISTICS................................................................................................. 18

ixel Format Definition....................................................................................................................... 18

ignal Description.............................................................................................................................. 19

ower ON/OFF Sequence................................................................................................................. 23

ND PIN ASSIGNMENT .................................................................................. 24

FT LCD Module............................................................................................................................... 24

Assignment ...............................................................................................................................................24

D Connector on Backlight Unit ...................................................................................................... 25

LED Pin assignment .......................................................................................................................................25

onnector Dimension .............................................................................................................................26

LED C

7.2.3

LED

Mating housing dimension ......................................................................................................................26

8 RELIABILITY TEST ................................................................................................................. 27

9 SHIPPING LABEL ................................................................................................................... 28

10 MECHANICAL CHARACTERISTICS ...................................................................................... 29

11 PACKING SPECIFICATION .................................................................................................... 31

11.1 Packing Flow..................................................................................................................................... 31

2

11.

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

allet and Shipment Information........................................................................................................ 32

P

ent version 0.3 2

docum

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

Records of Rev

ision

ZXXS215-L01

ersion and Date Page Old description New Description Remark

V

0.1

2012/08

0.2

2012/08

11

25

29,

/15

/16

First Version

pdate thickness.

6

30

U

D

elete 2.3 Mechanical Characteristics.

A

dd mechanical diagram

0.3

2012/08

12

/17

7

De

fine Color / Chromaticity

Coordinates (CIE)

Update Max value of LED forward Voltage variation

ent version 0.3 3

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

17

2012/08

17

12

/27 6

Product Specification

Add Min value Voltage

fy Physical Size

Modi

Update Voltage

Update Max of LED forward Voltage variation

Min. of Light Bar Operation

of Light Bar Operation

ZXXS215-L01

ent version 0.3 4

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

ZXXS215-L01

1 Handl

Product Specification

ing Precautions

1) Since front polarizer is easily damaged, pay attention not to scratch it.

2) Be sure to turn off power supply when inserting or disconnecting from input connector.

3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.

4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.

5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.

6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth

when handling.

7) Do not open or modify the Module Assembly.

8) Do not press the reflector sheet at the back of the module to any directions.

9) In case if a Module has to be put back into the packing container slot after once it was taken out

from the container, do not press the center of LED light bar edge. Instead, press at the far ends

of the LED light bar edge softly. Otherwise the TFT Module may be damaged.

10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the

Interface Connector of the TFT Module.

11) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module

even momentary. At designing the enclosure, it should be taken into consideration that no

bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module

may be damaged.

12) Small amount of materials having no flammability grade is used in the LCD module. The LCD

module should be supplied by power complied with requirements of Limited Power Source

(IEC60950 or UL1950), or be applied exemption.

13) Avoid touching COF position while doing mechanical design.

14) While storing modules as spares for a long time, the following precautions are necessary:

¾ Store modules in a dark place. Do not expose them to sunlight or fluorescent light.

¾ Keep the temperature between 5°C and 35°C at normal humidity.

ent version 0.3 5

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

ZXXS215-L01

2 Gener

al Description

Product Specification

A

U OPTRONICS CORPORATION

This specification applies to the 21.5 inch-FHD color a-Si TFT-LCD Module T215HVN01.0. The

display supports the FHD - 1920(H) x 1080(V) screen format and 16.7M colors (RGB 8-bit data).

The light source of this TFT-LCD module is W-LED. All input signals are 2-channel LVDS interface

and this module doesn’t contain a driver for backlight.

2.1 Display Characteristics

The following items are characteristics summary on the table under 25°C condition:

Ite

ms

Screen Diagonal [mm] 546.865(21.53”)

Act

ive Area [mm] 476.64 (H) x 268.11 (V)

els H x V 1920(x3) x 1080

Pix

Uni

Speci

t

fication

Pixel Pitch [um] 248.25 (per one triad) ×248.25

Pix

el Arrangement R.G.B. Vertical Stripe

Display Mode VA Mode, Normally Black

W

hite Luminance ( Center ) [cd/m2] 600cd/m2 (Typ.)

Cont

rast Ratio 3000 (Typ.) (TBD)

Optical Response Time [msec] 25ms (Typ., on/off) (TBD)

Nom

inal Input Voltage VDD [Volt] + 5.0 V

28 watt

Pow

er Consumption

(VDD line + LED line)

eight [g] 1,800 gram (Typ.)

W

Phy

sical Size [mm]

rical Interface Dual channel LVDS

Elect

Support Color 16.7M colors (RGB 8-bit)

S

urface Treatment Anti-Glare, 3H

[Watt]

(VDD line : PDD (typ), All white pattern at 60Hz =

3.45W

LED line : PBLU (typ) = 13.1W)

495.

6 (W) * 292.2 (H) *10.6 (D) (TYP.)

emperature Range

T

Operating

Storage (Shipping)

RoHS Com

CO Compliance TCO 6.0 Compliance

T

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

pliance RoHS Compliance

ent version 0.3 6

[°C]

0 to +50

-20 to +60

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

2.2 Optical Characteristics

The optical characteristics are measured under stable conditions at 25°C:

Ite

m

Viewing Angle [degree]

Cont

rast Ratio

Response Time [msec]

Uni

t

Nor

Condi

Hor

CR

V

CR = 10

R

Falling

tions

izontal (Right)

= 10 (Left)

ertical (Up)

(Down)

mal Direction

ising Time (TrR)

Time (TrF)

Min

.

75

T

BD

- TB

ZXXS215-L01

Ty

p.

89

T

BD

D TBD

M

ax.

-

- 3

Not

2

4

e

Rising + Falling - TBD TBD

Red x

Red y

Color / Chromaticity

dinates (CIE)

Coor

Color

Coordinates (CIE) White

Cent

ral Luminance

inance Uniformity

Lum

osstalk (in 60Hz)

Cr

Flicker dB TBD 9

[cd/

[%

Green x 0.283 0.313 0.343

G

reen y

Blue x

Blue y

Wh

White y 0.299 0.329 0.359

200 250 - 6

m2]

]

75 80 - 7

]

T

ite x

0.

615 0.645

304 0.334

0.

606 0.636

124 0.154

0.

014 0.044

283

0.

313

0.

675

364

666-

184

074

343

BD

5

8

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

ZXXS215-L01

Note 1: Measurement Method

The LCD module should be stabilized at given temperature for 30 minutes to avoid abrupt

temperature change during measuring (at surface 35°C). In order to stabilize the luminance, the

measurement should be executed after lighting Backlight for 30 minutes in a stable, windless and

dark room.

Photo Detector

Meas

ured Distance

LCD P

anel

Center

of the screen

FT-LCD Module

T

Note 2: Definition of Viewing Angle measured by ELDIM (EZContrast 88)

Viewing angle is the measurement of contrast ratio Њ10, at the screen center, over a 180°

horizontal and 180° vertical range (off-normal viewing angles). The 180° viewing angle range is broken down as follows; 90° (ș) horizontal left and right and 90° (ĭ) vertical, high (up) and low

(down). The measurement direction is typically perpendicular to the display surface with the screen

rotated about its center to develop the desired measurement viewing angle.

ent version 0.3 8

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

ZXXS215-L01

Note 3: Contrast Ratio measured by TOPCON SR-3

Note 4: Definition of Response time measured by Westar TRD-100A

The output signals of photo detector are measured when the input signals are changed from “Full

Black” to “Full White” (rising time, T

), and from “Full White” to “Full Black” (falling time, TrF),

rR

respectively. The response time is interval between the 10% and 90% (1 frame at 60 Hz) of

amplitudes.

ptical

O

response

100

90

10

0

%

T

rF

Wh

ite Black

1 Frame 1 Frame

Bl

ack

T

rR

Wh

ite

T

+ TrF = 5 msec (typ.).

rR

Note 5: Color Chromaticity and Coordinates (CIE) measured by TOPCON SR-3

Note 6: Central Luminance measured by TOPCON SR-3

Note 7: Luminance Uniformity of these 9 points defined as below and measured by TOPCON

SR-3

Uniformity =

uminance Maximum

ent version 0.3 9

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

9)-(1 points 9in Luminance Minimum

9)-(1 Points 9in L

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Product Specification

Note 8: Crosstalk defined as below and measured by TOPCON SR-3

CT = | YB – YA | / YA × 100 (%)

Where

YA = Luminance of measured location without gray level 0 pattern (cd/m2)

YB = Luminance of measured location with gray level 0 pattern (cd/m2)

ZXXS215-L01

Note 9: Test P

attern Sub-checker Pattern measured by TOPCON SR-3

R G B R G B

ray Level = L127

G

R G B R G B

Gray Level = L0

ethod: Record dBV & DC value with TRD-100

M

Am

plitude

DC

AC

Time

log20(dB)Flicker =

Le

Hz) 30Level(at AC

vel DC

ent version 0.3 10

docum

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

ZHIXUAN ZXXS215-L01 Specification

Specifications and Main Features

Frequently Asked Questions

User Manual