Zhejiang Yankon Group YKH0032 Users manual

User manual

1. InsertingtheSIMcard

2. Powering up the gateway（Inputvoltage: 120-277V,Frequency: 60Hz）

3. Observingthe status of indicators. Waiting 2 minutes, if the blue light
and the green light is blinking and the red light is extinguishing,the
gateway is working.

Users can issue control commands on their phones or computers. And the
3G antenna receives data from the cloud.The gateway converts 3

into zigbee data. Finally, the light is controlled by zigbee antenna.

G data

1. Account registration-Send the username and email address

[e-mail].

2. Login username by https://www.megaman-system.com/login.

3. Send the Mac of lights and the gateway to the background

administrator([e-mail]) for addition.

4. Control lights on the web.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement

This equipment should be installed and operated with minimum distance 20cm between the

radiator& your body. This transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

—
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.
—Consult the dealer or an experienced radio/TV technician for help.

ISED RSS Warning:

This device complies with Innovation, Science and Economic Development Canada licence-

exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device

may not cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

ISED RF exposure statement:

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator& your body.This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôlés.Installation

et mise en œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton

corps.Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec d’autres.