Zhejiang Yankon Group MXLLED User Manual

LIGHTING

Model # MXL2048-LED40K8040

Shop Light

Installation Instructions

ATTACH YOUR RECEIPT HERE

Item Number

Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-866-492-6566.

Purchase Date

www.energeticlighting.com

1

PACKAGE CONTENTS

INSTALLATION INSTRUCTIONS

A

B

Part Item Name Qty.

A

Fixture

B

Chain

C

“J” Hook

C

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.

• Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or

turn off the circuit breaker.

• Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

• This product must be installed in accordance with local, state and national electrical codes.

• Installation work shall be completed by a licensed installer that is familiar with the

construction and operations of the product.

CAUTION:

• The fixture body is one piece. Do not disassemble it.

• This product can NOT be used with a dimmer switch.

NOTICE

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The user
is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio/TV technician for help.

• This equipment should be installed and operated with a minimum distance 20cm between
the radiator and your body.

• If the fixture will not be operated for a long period of time, the power plug should be
disconnected from the outlet.

1. Mark two (2) locations on mounting surface spaced
apart by 34-in.

1
2
2

Ensure that the mounting holes will be located on a
sturdy surface such as wood rafters, plywood or
drywall studs. The mounting holes should NOT be

Mark these two locations
on mounting surface

located over a drywall surface without a backing
support, as this may not provide enough support for
the weight of the fixture.

34-in.

Fig. 1

2. Drill pilot holes in each of the two marked locations.
Screw in the two “J” hooks (C), one in each pilot hole.
Hook the loop end of one chain (B) onto each “J”
hook (C).

Pilot holes

C

B

Fig. 2

3. Insert the hook end of one of the chains (B) into the
support slots on the fixture back as shown in Fig. 3 to

B

support the fixture on the mounting surface. Repeat
for the second mounting hole.

A

Fig. 3

www.energeticlighting.com www.energeticlighting.com

32