Zhejiang Yankon Group LB014ABV User Manual

Wireless power supply

Models：LB014ABV-1000C
Input: 120VAC 60Hz 14.5W
Output: 12Vdc 1A max
Manufacturer：Zhejiang YanKon Group Co.,Ltd.

Warning：
a. For indoor use only.
b. This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux

deux conditions suivantes :

1) L’appareil ne doit pas produire de brouillage;

c. 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

Caution: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

If this certified product is installed inside the other device, and the label is not visible,
then the outside of the host must be labeled with the following content:

Contains FCC ID: 2AL76LB014ABV and IC: 24219-LB014ABV

When installing this product inside a host, measures should be taken to feed it with a 120
Volts AC 60Hz current, regardless of if the power switch of the Host affects powering this
device.

This could be done by connecting the power wire (Black and white wires) in parallel with the

power feeding circuitry of the host.