ZHEJIANG JIECANG LINEAR MOTION TECHNOLOGY JCHR35H4 User Manual

JCHR35H4 Remote control User manual

、

一

Remote control Effect Picture

JCHR35H4-1 JCHR35H4-2 JCHR35H4-3

二、 Remote control function description

2.1、 Pairing:

Remote control pair code:

1) put the battery into the remote control.

2) power the control box (supporting our control box).

3) hold down and hold the code control button on the control box to guide
the code indicator light to go out and release it. At this time, the code on the
control box indicates LED flashing, and the control box is in the state of pending
pairing.

4) at the same time, hold down the back up button on the remote control
and the leg up button. When the LED on the control box to be matched stops
flashing and the buzzer makes a sound, the pairing operation is completed.To
test whether or not the pairing is successful, back up/down, legs up and down

keys, buttons and so on related to drive, if you can hear the "tick" sound emitted
by the relay, specification matching success.Otherwise, repeat all the above
steps.

Note: after successful code alignment, operate any two buttons at the same time during
use, and the remote control will not send signals.

三三三三、、、、 Function description

1, HEAD, FOOT, or +, - to vibration motor function: when the motor is not open, the

operating HEAD, FOOT, or + corresponding motor respectively open, when the motor in

open state, the operating TIME/ALL OFF key function as closed two vibrating motors.

2. When the motor is not on, operate the TIME/ALL OFF key, then the timing indicator

light will be turned OFF after it is on 5S, and the lighting sequence of the timing indicator

will be from 10min to 20min to 30min.After each power failure, the power is started from

10min.

3. Each key of the remote control shall have backlight lamp, and the color shall be

blue.10min/20min/30min timing indicator LED lamp is also blue;The flashlight lamp is

bright and white.

4. Operate the flashlight button, and the flashlight lamp will be lit. If you no longer operate

the button after releasing the button 5S, the flashlight will be automatically extinguished.

5. The operation time of the flashlight button is greater than or equal to 5S, when the blue

backlight of the remote control flashes. At this time, operate any key in the ZG/ anti-snore

/TV/MEMORY A/MEMORY B button, and the blue backlight lamp stops flashing.If the

operation of the other buttons does not work, and the blue backlight lamp has been

flashing, the flashing time is 10S.

6. Operate any button, and the blue backlight lamp on the remote control button will be lit.

Release the button 5S and it will go out automatically.

7. Operate any two buttons at the same time, and the remote control will not send signals.

8. When the button loosens, the button value 0x00 shall be sent to indicate the release of

the button.