Zhejiang Homeimpression Furniture S199 User Manual
FEATURES
DC In
A9A8
USB
SD
Audio in Headphones
A10 A11 A12
Play/Pause
Prev Next
Treble Bass
OFF ON
Volume
A6A7A5 A4 A3 A2 A1
A-Control Panel
A1-Power On/Off Buon Switch and Volume Adjustment
A2-Bass Volume Adjustment
A3-Treble Adjustment
A4-Headphone Plug in Jack
A5-Audio Input for Linking Futon
A6-9V DC Power Input Jack
A7-SD CARD
A8-USB IP/Charging
A9-Power Indicator Light
A10-Short press for play/pause
A11-Short Press for Prev
A12- Short Press for Next
B-Accessories Supplied
B1-1.5m 3.5mm Stereo to 3.5mm stereo plug cable(1 PC)
B2-INPUT:100-240V AC 50/60Hz
OUTPUT:9V DC 1.5A 13.5W Main POWER Adapter
Signal-to-Noise Rate(Amplifier):Subwoofer:>65db
Satellite: >60db
Frequency Response:30HZ∽20KHZ
Distoron:Subwoofer:<1%(F=100HZ)
Satellite:<1%(F=1KHZ)
Input:DC 9V/1.5A
MP3/MP4/VCD/DVD/GAME
Play/Pause
Prev Next
Treble Bass
OFF ON
Volume
DC In
USB
SD
Audio in Headphones
step：
1：Unpack the power adapter DC9V/1.5A and connect it to the main power outlet, then to the
power jack on the control panel.(A6)
2：Start by rotang clockwise, confirm the Bluetooth light on, connecng by phone in pass
code:0000
3：Both SD/U and Audio can be stand by plug in,(red in Audio model; red flashing in SD/U model)
4：Short press Play/Pause for play and pause；press 2 seconds change into Bluetooth/SD/U/Audio
5：Short press for prev, long press for volume down(only work on Bluetooth and SD/U)
6：Short press for next, long press for volume rise(only work on Bluetooth and SD/U)
7：VOLUME: Power on/off buon switch and volume adjustment
8：BASS: bass volume adjustment
9：TREBLE:Treble adjustment
10：Headphone: Headphone plug in jack
FCC Warning Statement
Changes or modificaons not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protecon against harmful interference in a residenal installaon. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not occur in a
parcular installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separaon between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...