Zhejiang Haoda science and technology ZN803 User Manual

Bluetooth speaker

User Manual

Model: ZN-803

■ Bluetooth Instruction(Note: The Bluetooth code is B86, pair code: 0000)

1. Long press " " for 2seconds to power on, hear prompt sound “Bluetooth”,
the blue LED light flash quickly.

2. It is in Bluetooth pairing mode.

3. On your portable device, turn Bluetooth on, search for Bluetooth devices

4. Select “B86” and you will hear prompt sound “Bluetooth Connected”, the blue

LED light keeps on.

5. It is ready for use.

6. Long press “+/-” to increase/decrease volume

Short press”+/-” to next/previous song
Short press" " to play/pause

7. Long press " " for 2seconds to power off

Remark: 1. If there is no operation within 15 minutes, the Bluetooth speaker will
power off automatically.

2. The Bluetooth device will be connected automatically if it has been paired before.

3. If the Bluetooth range over than10meters or disconnected by phone, there is

prompt sound “disconnected” and the blue LED light flash quickly.

■ Hands free function

Short press " ” to answer or end an incoming call

Long press " ”to refuse an incoming call

Twice press " ”to redial the last phone number outgoing call.

Short press " ”to cancel redialing the last phone number outgoing call.
Remark: The blue LED light flash slowly during Hands free function.

■ Charging the Battery
Before first use, please charge the Bluetooth speaker.
Plug the provided USB charging cable into the speaker and a powered USB port.
While charging, the LED light is red. Once fully charged, it will turn off.
Charging time: 1.5hours

Remark: 1. The Bluetooth speaker can be used during charging.

2. There is an alarm “low battery, please charge” every 30s if low battery.

■ Specifications:

Speaker: D40mm (130HZ-20KHZ)
Power output: 2W 3Ω

SNR: ≥90±5dB
Bluetooth version: 4.2
Built-in battery: 500mAh
Play time: 3.5hours
Material: ABS+silicon
Size: 80*73*63.8mm

NOTE: This equipment has been tested and found to comply with
the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are
designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and can
radiate radio
frequency energy and, if not installed and used in accordance with
the instructions,
may cause harmful interference to radio communications. However,
there is no
guarantee that interference will not occur in a particular installation.
If this
equipment does cause harmful interference to radio or television
reception, which
can be determined by turning the equipment off and on, the user is
encouraged to
try to correct the interference by one or more of the following
measures: