Zhejiang Feishen Vehicle FSCMYKQGT0006 User Manual

GT0006遥控器功能示意图
STEERING WHEEL
THROTTLE TRIGGER
GT0006 RADIO MANUAL
ST REV
POWER LED
ST TRIM
D/R
POWER SW
TH REV
POWER CHECK
TH TRIM
BIND
Radio
转向手轮
油门摇杆
遥控器外观
转向正反向开关
电源指示灯
转向微调旋钮
油门微调旋钮
电源开关
油门正反向开关
电量指示灯
转向大小动作控制旋钮
对频按钮
2
带马达模型的安装连接
INSTALLATION FOR MOTOR MODELS
BINDING
5.Observe the LED on the receiver, if find that the LED is not flash anymore and that means successful matched. (This process about 5S)
6.Release the match button on the transmitter, take out the match line.
7. Install the servo and then test.
8. If the test fail, please repeat the action above.
9. If the test success, then insert the power supply port into VCC, match complete.
2. Insert the matching lines to the channel BIND/CH3 port of the receiver (Pic 1)
1. Install the battery to 2.4Gtransmitter and shut it down.
4. Press and hold the button on the transmitter, and then switch on the power supply.
3. Connect the receiver battery to VCC port of the receiver, on the same time the 2 LED are flashing and this means the receiver are to the matching status.
SPC调速器
SWITCH
开关
Servo伺 服器
Receiver接收机
CH2
CH1
MOTOR马达
BATTERY电池
Battery
电池
LED
Bind key
对码按钮
Match line
对码线
Receiver
接收
Loading...
+ 1 hidden pages