Zhejiang Dahua Vision Technology DH IPC AX6H Users manual

With imou AppOperating

Installing

Camera

About the Guide

- This quick start guide is for reference only. Minor difference might be

found in user interface.

- All the design and software here are subject to change without prior

written notice.

- All trademarks and registered trademarks mentioned are the

properties of their respective owners.

- Please visit our website or contact your local service engineer for

more information.

- If there is any uncertainty or controversy, please refer to our final

explanation.

Step 1

Scan the following QR code or search “imou” in Google Play or App
Store to download and install imou App.

Step 2

Run imou App, and then register an account for first use.

Step 3

Connect the camera to power source with the power adapter.

Step 4

Wait for booting to be finished, and then the camera indicator flashes
with green light.

Step 5

Connect your smart phone to your Wi-Fi network, and make sure your
smartphone is connected to Wi-Fi network with 2.4 GHz band, and then
do the following operations to finish adding camera.

Note:

If you have more than one camera, do step 5 to add them one
by one.

If the Wi-Fi network changed or the indicator status goes wrong,
reset the camera, and then do step 5 to add it again.

Make sure the mounting surface is strong enough to hold at least
three times of the device weight.

Mounting Surface

Positioning Map

Expansion Bolt

Mounting Plate

Self-tapping Screw

Camera

Step1 Drill screw holes on the mounting surface as the mounting plate

shows, and then put in the expansion bolts.

Step2 Attach the mounting plate to the mounting surface with the

self-tapping screws.

Step3 Attach the camera to the mounting plate, then power it up, and

then, adjust the lens to the ideal angle.

Camera

Introduction

Built-in Speaker

Camera ×1 Power Cable ×1 Power Adapter ×1

QSG ×1 Screw Package ×1

Mounting Plate ×1

Positioning Map ×1

Micro SD Card Slot

Power Port

Note:

Press the Reset/WPS button to enable WPS.

Press and hold the

The pattern of the LED indicator is included in the following table.

LED Indicator Status

Off

Red light on

Green light flashing

Green light on

Red light flashing

Green and Red light

flashing alternately

button for 10 s to reset the camera.

Reset/WPS

Powered off/LED turned off

Rebooting after reset
Booting

Device malfunction

Waiting for network

Operating properly

Network connection failed

Firmware updating

Reset/WPS Button

Ethernet Port