Zero Gravity ZX10 User Manual

23, 24, 25-263

SPORTBIKE SADDLES & WINDSCREENS

install Rev A

nstallation Instructions for 23, 24, 25 Series Windscreen 2011- Present Kawasaki ZX-10R

I

Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe and fun rid­ing. This instruction manual gives you an in-depth look at the installation process. To receive further assistance or parts please e-mail
[e-mail].

ZG Fasteners

Factory Washers Reuse

actory Windscreen Cowling

Windscreen

ZG Spacers

Factory Wellnuts

3. Remove the 6 factory washers and reuse them on ZG fasteners. Place
your Zero Gravity windscreen on the bike and align the windscreen
holes with the windscreen cowling holes.

4. Insert 2 of the 6 supplied ZG windscreen fastener screws into the 2
bottom holes and screw them in a few turns into the wellnuts.

5. Lift the rear edge of the screen so the screen tilts up slightly.

6. Place the 2 spacers between the windscreen and the windscreen cowl-

ing so they align with the 2 upper holes of the windscreen and the
well nut receptacle holes of the cowling. (See Well Nut Locations).

7. Insert the 2 fasteners and washers into the upper windscreen holes so
that they pass through the windscreen, spacers, and then into the well-

2. Before installing your new Zero

Gravity screen, locate the 2 spacers and 6

fasteners provided with your windscreen.

F

1. Remove the factory windscreen.

Well Nut Locations

Spacer location

between

windscreen

and cowling

nut threaded receptacle. (See image up above).

8. Add the last 2 corner fasteners, then tighten all 6 windscreen fas­tener screws so that the windscreen is firmly in place.

DO NOT OVER-TIGHTEN!

1 Spacer installed

between wellnut

nd screen.

a

Well Nut

Locations

1 Spacer installed

between wellnut

and screen.

WWW.ZEROGRAVITY-RACING.COM