Zero Gravity VFR 800 User Manual

454 install

Rev. A

Honda VFR 800 2002 - 2010 DIY Windscreen Install

Installation Instructions for Honda VFR 800 2002 and up.

Thank you for purchasing Zero Gravity’s windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the installation process. To receive further assistance or parts please

e-mail [e-mail].

PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN

Helpful hints: Use m etric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break
without much warning.

Please Note:

The factory Honda wind­screen incorporates two
tabs that fasten the screen
to the fairing cowl. These
tabs have been eliminated
on your ZG screen. This
was done deliberately by
the ZG designers to aid in
our ability to manufacture
this screen and for ease of
installation.

Reclined

back,
positioned
behind the

fairing.

Positioned

in front of

the fairing

FIG1

Fig 1. Remove both mirrors. Locate both fasteners

located on the outside and inside fairing. Be careful not
to drop the mirrors!

Fairing

Slots

U-Hooks

FIG3

Fig 3. HERE IS THE TRICKY PART! Locate the fair-

ing slots and windscreen U hooks before applying
any inserting pressure. There will be four u-hooks,

two on each side.

(See FIG3A).

FIG2

Fig 2. After removing the stock windscreen, insert the

Zero Gravity windscreen from the back of the fairing in
a reclined position as shown in

Location
For Light
Pressure

Fig 2.

FIG3A

Fig 3A. Insert the U-hooks into their respective slots

by applying a light pressure as shown. This photo
shows pressure locations on either side of the screen.

Be careful not to exert to much force!

WWW.ZEROGRAVITY-RACING.COM

1

454 install

Rev. A

Honda VFR 800 2002 - 2010 DIY Windscreen Install

Slightly off positioned

standoff hole

Side Mirror

mounting holes

Fairing

stay

standoff

FIG4

Fig 4. Viewing from the back of the fairing, locate the

fairing stay standoff above the mirror mounting holes.
It should look like this on both sides of the windscreen.

Slide

down

FIG5

Fig 5. Now you are ready to lock the screen into the

fairing.
the windscreen down. The slide is no more than 1/4”.

Apply light pressure from the top to slide

Correctly positioned

standoff hole

FIG6

Fig 6. Viewing from the back of the fairing, both fair-

ing stay standoffs should be in alignment with the Zero
Gravity windscreen fairing stay standoff openings.

Fig 7 for closeup.

See

Note: Revert back to steps Fig 3 ~ Fig 6 if alignment isn’t achieved.

Please see www.zerogravity-racing.com for

further information concerning this product.

2

WWW.ZEROGRAVITY-RACING.COM

FIG7

Fig 7. Fairing stay standoff in correct location. Hand

tighten all fasteners then reinstall mirrors.