Zero Gravity VFR 1200F User Manual
455 install
S
PORTBIKE SADDLES & WINDSCREENS
Honda VFR 1200F 2010 - 2013 DIY Windscreen Install
Installation Instructions for Honda VFR 1200F 2010 and up.
Thank you for purchasing Zero Gravity windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the installation process. To receive further assistance or parts please
e-mail techinfo@zerogravity-racing.com.
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
Helpful hints: Use metric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break
without warning.
Flex the
corner of
the fairing.
(Both sides)
Remove two
allen screws
(bothsides)
FIG1
Fig 1. Remove both mirrors. Locate both fasteners
located on the inside fairing. Also, remove inner plastic that’s covering both left & right two allen screws.
Fairing
Fairing
T-Hooks
Retention
Clip
FIG2
Fig 2. After removing the mirrors, flex the corner fair-
ing to expose the next step in unhooking the stock windscreen as shown in Fig 3.
Clip and T-Hook must
be separated before
removing screen .
FIG2A
Fig 2A. HERE IS THE TRICKY PART! Locate the
fairing retention clip and windscreen T-Hooks before
applying any movement pressure. There will be
two T-Hooks, one on each side.
(See FIG3).
WWW.ZEROGRAVITY-RACING.COM
FIG3
Fig 3. Separate T-Hooks from the retention clip by
applying a light pressure from the corner fairing and
work the light pressure down as shown. (Both Sides)
Be careful not too exert to much force!
1
455 install
S
PORTBIKE SADDLES & WINDSCREENS
Honda VFR 1200F 2010 - 2013 DIY Windscreen Install
Lift Windscreen away from
the Mirror mounting location
inish Plate
F
lips &
C
etention
R
ale Location
M
FIG4
Fig 4.
from the mirror mounting standoffs. It should look like
this on both sides of the windscreen.
Locate the upper fairing, Lift windscreen away
Slide
down
FIG6
Fig 6. Now you are ready to unlock the screen from
the fairing. Apply light pressure from the top
of the back side of the finish plate. There are
three retention locations on top to dislodge and also
one located at the very bottom of the finish plate.
Apply light pressure separating the clip from the fairing, and slide the windscreen/finish plate down.
Note: The finish plate is attached to the stock
windscreen.
Remove
Finish Plate Clips
& Retention
Female Location
Remove
FIG5
Fig 5. Overview of Windscreen and finish plate re-
moving locations.
Note: The finish plate is attached to the stock
windscreen by two phillips screws.
Remove
2
FIG7
Fig 7. Now you are ready to separate the finish plate
from the stock windscreen. Locate the two Phillips
screws and remove.
WWW.ZEROGRAVITY-RACING.COM
Loading...