Zephyr AHG-00WH, AHG-00BL User Manual

Pattern Glass

AHG-00BL
AHG-00WH

For use with Horizon range hood

customer service

1.888.880.8368

User instructions Pag. 2

Notice d’utilisation Pag. 4

Manual de utilización Pag. 6

Istruzioni per l’uso Pag. 8

The glass can be installed
either prior to or after in­stallation of the hood. If the
hood has not been mounted
to the wall, place it on a so­lid work surface.

1. Open the top glass door. See Fig.1

WARNING! Hold the glass to prevent it from falling
after the next stage.

Installation instructions

2. Undo the (6) wing nuts
securing the glass to the
panel. Fig.2

www.zephyronline.com

3. Remove the glass.

A

4. Position the glass from the kit
on the door panel by sliding it
until it touches the rear lip ensu­ring that the pins are within the
slots. Fig.3B

B

B

- 2 -

5. Replace the 6 wing nuts,
tightening only the two at the
front and leaving the other 4
loose. Fig.4

6. Close the door carefully un­til it latches.

- Check for correct alignment:
the side edges have to be aligned, and the distance between the top se­cured glass and the lower glass should be approximately 1/16” across the
whole width. Fig. 5

- If the glass is po­sitioned correctly
you may continue
to step 9, otherwise
please continue to
the next stage.

min 1/16"

Installation instructions

7. Open the door
again, then loosen
the 2 front wing
nuts and adjust the
alignment by sli­ding the glass.

8. Tighten the 2 front wing nuts and try closing the door again.

Please Note! If the alignment is still not correct, repeat the procedure
from step 7.

9. Open the door and tighten the 4 remaining nuts.

Now the glass has been fully secured to the hood.

- 3 -

Il est possible d’installer le
verre avec le produit déjà  xé
au mur ou avant sa  xation. Si
l’appareil n’a pas encore été
 xé au mur, posez-le sur un
plan de travail stable.

1. Ouvrir la
porte. Fig.1

Notice d’utilisation

ATTENTION! Maintenez le verre pour éviter qu’il tombe

après la phase suivante.

2. Dévissez les (6) écrous
oreilles qui  xent le verre
au panneau. Fig.2

www.zephyronline.com

3. . Enlevez le verre.

A

4. Positionnez le verre du kit sur
le panneau, en le faisant glisser
jusqu’à la butée arrière et assurez­vous que les goujons rentrent dans
les fentes. Comme illustré  g.3B

B

B

- 4 -