Zep ZUWLFF5G User Manual

SAFETY DATA SHEET
ZEP WET LOOK FLOOR POLISH RTU 5 GL
Version 3.1
Print Date 04/26/2019
Material name
:
ZEP WET LOOK FLOOR POLISH RTU 5 GL Material number
:
ZUWLFF5G
Company
:
Zep Inc.
Address
:
350 Joe Frank Harris Parkway, SE Emerson, GA 30137 Telephone
:
404-352-1680
Emergency telephone numbers
For SDS Information
:
Compliance Services 1-877-428-9937
For a Medical Emergency
:
877-541-2016 Toll Free - All Calls Recorded
For a Transportation Emergency
:
CHEMTREC: 800-424-9300 - All Calls Recorded. In the District of Columbia 202-483-7616
Recommended use
:
Floor Care Appearance
liquid
Colour
milky, white
Odour
mild, ammoniacal
Substance / Mixture
:
Mixture
SECTION 1. PRODUCT AND COMPANY IDENTIFICATION
Manufacturer or supplier's details
Recommended use of the chemical and restrictions on use
Note: This product is labeled as a consumer product in accordance with the United States Consumer Product Safety Commission regulations. The warnings presented below in this Safety Data Sheet (SDS) comply with the 2012 OSHA Hazard Communication Standard (GHS - Globally Harmonized System of Classification and Labeling). The requirements for the labeling and warnings of consumer products may differ from those required for GHS based hazard communication.
SECTION 2. HAZARDS IDENTIFICATION
Emergency Overview
GHS Classification
Not a hazardous substance or mixture.
GHS label elements
Not a hazardous substance or mixture.
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous components
1 / 10
SAFETY DATA SHEET
ZEP WET LOOK FLOOR POLISH RTU 5 GL
Version 3.1
Print Date 04/26/2019
Chemical name
CAS-No.
Concentration [%]
2-(2-ethoxyethoxy)ethanol
111-90-0
>= 1 - < 5
tris(2-butoxyethyl) phosphate
78-51-3
>= 1 - < 5
General advice
:
Do not leave the victim unattended.
If inhaled
:
If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.
In case of skin contact
:
If skin irritation persists, call a physician. In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash contaminated clothing before re-use.
In case of eye contact
:
Flush eyes with water as a precaution. Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist.
If swallowed
:
DO NOT induce vomiting unless directed to do so by a physician or poison control center. Keep respiratory tract clear. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.
Most important symptoms and effects, both acute and delayed
:
Effects may be delayed, symptoms may include minor eye or skin irritation. Overexposure may cause mild eye or skin irritation.
Notes to physician
:
Treat symptomatically. Symptoms may be delayed.
Suitable extinguishing media
:
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Unsuitable extinguishing media
:
High volume water jet
Hazardous combustion products
:
Carbon dioxide (CO2) Carbon monoxide Smoke
Specific extinguishing methods
:
Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Further information
:
Standard procedure for chemical fires.
The exact percentages of disclosed substances are withheld as trade secrets.
SECTION 4. FIRST AID MEASURES
SECTION 5. FIREFIGHTING MEASURES
2 / 10
SAFETY DATA SHEET
ZEP WET LOOK FLOOR POLISH RTU 5 GL
Version 3.1
Print Date 04/26/2019
Collect contaminated fire extinguishing water separately. This must not be discharged into drains.
Special protective equipment for firefighters
:
Wear self-contained breathing apparatus for firefighting if necessary.
Personal precautions, protective equipment and emergency procedures
:
Use personal protective equipment.
Environmental precautions
:
Prevent further leakage or spillage if safe to do so. Prevent product from entering drains. If the product contaminates rivers and lakes or drains inform respective authorities.
Methods and materials for containment and cleaning up
:
Wipe up with absorbent material (e.g. cloth, fleece). Keep in suitable, closed containers for disposal.
Advice on safe handling
:
Avoid contact with skin and eyes. For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Dispose of rinse water in accordance with local and national regulations.
Conditions for safe storage
:
Electrical installations / working materials must comply with the technological safety standards. Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage.
Materials to avoid
:
Oxidizing agents Do not store near acids. Do not freeze.
Components
CAS-No.
Value type (Form of exposure)
Control parameters / Permissible concentration
Basis
2-(2-ethoxyethoxy)ethanol
111-90-0
TWA
25 ppm
US WEEL
Engineering measures
:
none
SECTION 6. ACCIDENTAL RELEASE MEASURES
SECTION 7. HANDLING AND STORAGE
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Components with workplace control parameters
3 / 10
Loading...
+ 7 hidden pages