ZEPTABS PLUS 1 BOX 24 EA
Zep Tabs Plus 1 BOX 24 EA
33427-4-1270
Material number
350 Joe Frank Harris Parkway, SE
Emerson, GA 30137
Telephone
Emergency telephone numbers
Compliance Services 1-877-428-9937
877-541-2016 Toll Free - All Calls Recorded
For a Transportation
Emergency
CHEMTREC: 800-424-9300 - All Calls Recorded.
In the District of Columbia 202-483-7616
Acute toxicity (Inhalation)
Specific target organ toxicity single exposure
Category 3 (Respiratory system)
H314 Causes severe skin burns and eye damage.
H331 Toxic if inhaled.
H335 May cause respiratory irritation.
SECTION 1. PRODUCT AND COMPANY IDENTIFICATION
Manufacturer or supplier's details
Recommended use of the chemical and restrictions on use
SECTION 2. HAZARDS IDENTIFICATION
Emergency Overview
GHS Classification
GHS label elements
1 / 12
ZEPTABS PLUS 1 BOX 24 EA
Prevention:
P260 Do not breathe dust or mist.
P270 Do not eat, drink or smoke when using this product.
P264 Wash skin thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/ protective clothing/ eye
protection/ face protection.
Response:
P301 + P330 + P331 IF SWALLOWED: Rinse mouth. Do NOT
induce vomiting.
P303 + P361 + P353 IF ON SKIN (or hair): Take off
immediately all contaminated clothing. Rinse skin with
water/shower.
P304 + P340 + P310 IF INHALED: Remove person to fresh air
and keep comfortable for breathing. Immediately call a
POISON CENTER/doctor.
P305 + P351 + P338 + P310 IF IN EYES: Rinse cautiously with
water for several minutes. Remove contact lenses, if present
and easy to do. Continue rinsing. Immediately call a POISON
CENTER/doctor.
P363 Wash contaminated clothing before reuse.
Storage:
P403 + P233 Store in a well-ventilated place. Keep container
tightly closed.
P405 Store locked up.
Disposal:
P501 Dispose of contents/container in accordance with local
regulation.
Substance / Mixture
Quaternary ammonium compounds, benzyl-C1218-alkyldimethyl, chlorides
Move out of dangerous area.
Get medical attention immediately.
Show this safety data sheet to the doctor in attendance.
Do not leave the victim unattended.
If unconscious, place in recovery position and seek medical
advice.
If symptoms persist, call a physician.
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous components
The exact percentages of disclosed substances are withheld as trade secrets.
SECTION 4. FIRST AID MEASURES
2 / 12
ZEPTABS PLUS 1 BOX 24 EA
Immediate medical treatment is necessary as untreated
wounds from corrosion of the skin heal slowly and with
difficulty.
Wash off immediately with plenty of water for at least 15
minutes.
Remove contaminated clothing and shoes.
Wash contaminated clothing before reuse.
If skin irritation persists, call a physician.
Small amounts splashed into eyes can cause irreversible
tissue damage and blindness.
Rinse immediately with plenty of water, also under the eyelids,
for at least 15 minutes.
Continue rinsing eyes during transport to hospital.
Remove contact lenses.
Protect unharmed eye.
Keep eye wide open while rinsing.
If eye irritation persists, consult a specialist.
Keep respiratory tract clear.
DO NOT induce vomiting unless directed to do so by a
physician or poison control center.
Do not give milk or alcoholic beverages.
Never give anything by mouth to an unconscious person.
If symptoms persist, call a physician.
Take victim immediately to hospital.
Most important symptoms
and effects, both acute and
delayed
Effects are dependent on exposure (dose, concentration,
contact time).
Effects are immediate and delayed.
Symptoms may include blistering, irritation, burns, and pain.
Symptoms of overexposure may include disorientation;
dizziness; and confusion. May progress to unconsciousness,
paralysis, and convulsions.
Symptoms may include shortness of breath, dry cough, and
irritation of the nose, eyes, lips, mouth, and throat.
Causes severe skin burns and eye damage.
Toxic if inhaled.
May cause respiratory irritation.
Review section 2 of SDS to see all potential hazards.
Treat symptomatically. Symptoms may be delayed.
Suitable extinguishing media
Water spray jet
Alcohol-resistant foam
Carbon dioxide (CO2)
Dry chemical
Unsuitable extinguishing
media
High volume water jet
Specific hazards during
Do not allow run-off from fire fighting to enter drains or water
SECTION 5. FIREFIGHTING MEASURES
3 / 12
ZEPTABS PLUS 1 BOX 24 EA
Hazardous combustion
products
Carbon dioxide (CO2)
Carbon monoxide
Nitrogen oxides (NOx)
Smoke
Chlorine compounds
Specific extinguishing
methods
Use extinguishing measures that are appropriate to local
circumstances and the surrounding environment.
Standard procedure for chemical fires.
Collect contaminated fire extinguishing water separately. This
must not be discharged into drains.
Fire residues and contaminated fire extinguishing water must
be disposed of in accordance with local regulations.
Special protective equipment
for firefighters
Wear self-contained breathing apparatus for firefighting if
necessary.
Personal precautions,
protective equipment and
emergency procedures
Use personal protective equipment.
Remove all sources of ignition.
Evacuate personnel to safe areas.
Beware of vapours accumulating to form explosive
concentrations. Vapours can accumulate in low areas.
Environmental precautions
Prevent product from entering drains.
Prevent further leakage or spillage if safe to do so.
If the product contaminates rivers and lakes or drains inform
respective authorities.
Methods and materials for
containment and cleaning up
Contain spillage, and then collect with non-combustible
absorbent material, (e.g. sand, earth, diatomaceous earth,
vermiculite) and place in container for disposal according to
local / national regulations (see section 13).
Avoid formation of respirable particles.
Do not breathe vapours/dust.
Avoid contact with skin and eyes.
For personal protection see section 8.
Smoking, eating and drinking should be prohibited in the
application area.
Dispose of rinse water in accordance with local and national
regulations.
Conditions for safe storage
Keep container tightly closed in a dry and well-ventilated
place.
Observe label precautions.
Electrical installations / working materials must comply with
the technological safety standards.
SECTION 6. ACCIDENTAL RELEASE MEASURES
SECTION 7. HANDLING AND STORAGE
4 / 12